Abstract:Due to the high voltage and high current working characteristics of EV driving system, strong electromagnetic interference is formed in the working process, and the shielding effectiveness of the high-voltage connector assembly connecting each part of the driving system is directly related to the level of its electromagnetic interference emission. The high-voltage connector is usually made by triaxial method. However, due to the influence of sample coupling length and cutoff frequency, the triaxial method is prone to produce a region of more than 25 MHz, resulting in test failure. Therefore, modeling analysis of the shielding effectiveness of the connector assembly in the early stage is crucial for the final development of a connector assembly with good shielding effectiveness. In this paper, an analytical optimization model named ZTD-Demoulin is proposed to calculate the transfer impedance value of the dynamic shielded wire (double-layer shielded) of the electric vehicle. The model takes into account the influence of the double-layer shielded cable (braided-belt and aluminum foil) on the DC resistance and small-hole inductance of the shielding layer, and analyzes the transfer impedance value which presents the shielding effectiveness of the connector assembly. Based on the double-layer shield optimization model, an optimization model of high-voltage connector assembly is established. This established model takes into account the influence of connector contact resistance and inductance value. Comparison between the triaxial coaxial method and the established model found that when Kconnector = 6Kcable, the fitting effect of the model was the best and the transfer impedance value above 25 MHz could be predicted.

Analysis of Cable Parameters on the Real Chassis by Measurement

Modeling and Evaluation of Common-Mode EMI Coupling Through Converter Chassis in Metro Traction System

Modeling of Common-Mode Current in Motor Cable of Inverter-Fed Motor Drive System

High Frequency Conducted Disturbance Analysis of Driving System in Fuel Cell Vehicle

System-Level Conducted EMI Model for SiC Powertrain of Electric Vehicles

Investigation on Steady State Characteristics and Loss Reduction Measures of 220 Kv Power Cables

Characteristics Analysis of the Conducted Disturbance in the Driving System of Fuel Cell Bus

Investigation of Ground Impedances effecting EMC during Charging Operations of Electric Vehicles

Characteristics of Common-Mode Conducted Current in Electric Vehicle

Investigation of conducted disturbance from driving system in fuel cell bus

Influence of System Layout on CM EMI Noise of SiC Electric Vehicle Powertrains

Statistical Analysis of Conducted Disturbance Sources in the Driving System of Fuel Cell Bus

A statistical model of noises at input port of inverter and its coupling to low voltage cable on fuel cell bus

Comparison of long cable impedances using multiphysics and equivalent circuit models

Modeling And Evaluation Of Common-Mode Interference Coupling Effects On Sensitive Cable In Motor Drive System

Electromagnetic Interference Shielding Performance Calculate Model for Double Layer Shielded Cable Connector in EV

Influence of Motor Cable on Common-Mode Currents in an Inverter-Fed Motor Drive System

Propagation features of conducted emi noise in electirc vehicle

Simulation Analysis of Grounding Characteristics of Cable Based on ATP-EMTP

Statistical Analysis Of Conducted Disturbance Source In Fuel Cell Bus

Electromagnetic Conductive Interference Characteristics in Driving System of Fuel Cell Bus