Abstract:Fuel cell vehicles have shown their advantages in clean run and high efficiency compared with the traditional internal combustion engine vehicles,but they would cause more serious EMC(Electromagnetic Compatibility) problems.So the EMC research about these new kinds of vehicles is being focused on.It is verified that the driving system on the fuel cell vehicle could generate high frequency disturbance for the switching of the IGBTs(Insulated gate bipolar transistors).This is one of the main conducted disturbances in fuel cell vehicle.High frequency circuit model of driving system is a very effective tool to research the transient response,which could help to reduce the related disturbance effect.This kind of model should include the time-variable parameters caused by the switching of the IGBTs and the frequency-variable parameters caused by the skin effect of the cables and the AC motor.In this paper,the fuel cell model and IGBTs model are set up based on the other's work.The frequency-variable parameters of the cables and the AC motor are measured on the real fuel cell bus.The vector fitting method is applied to fit the complex frequencyvariable parameters into rational form which could be transmitted into time-domain easily by convolution.Then the time-variable parameters and the frequency-variable parameters could be considered together in time domain.One advantage of this method is that it could avoid calculating a lot of frequency point as necessary in frequency domain method.Another is that it could be extended to consider more complex time-variable parameters of IGBTs.This method can save a lot of calculation time.The transient response is analyzed when one bridge of the inverter is switching.Simulation results fit well with the experimental data and this method is proved to be effective.

Electromagnetic Conductive Interference Characteristics in Driving System of Fuel Cell Bus

Conductive electromagnetic interferences of a fuel cell bus

Investigation of conducted disturbance from driving system in fuel cell bus

High Frequency Conducted Disturbance Analysis of Driving System in Fuel Cell Vehicle

Simulation on Conducted Disturbance in Driving System of Novel Fuel Cell Bus

Characteristics Analysis of the Conducted Disturbance in the Driving System of Fuel Cell Bus

Statistical Analysis of Conducted Disturbance Sources in the Driving System of Fuel Cell Bus

Statistical Analysis Of Conducted Disturbance Source In Fuel Cell Bus

Distribution and Characteristic of the Disturbances in the Driving System of a Fuel Cell Bus

Modeling and Evaluation of Common-Mode EMI Coupling Through Converter Chassis in Metro Traction System

Design and Optimization of a Modular Wireless Charging Scheme for Electric Buses with High Misalignment Tolerance

Systematic Analysis of Conducted Electromagnetic Interferences for the Electric Drive System in Electric Vehicles

Propagation features of conducted emi noise in electirc vehicle

Modeling And Evaluation Of Common-Mode Interference Coupling Effects On Sensitive Cable In Motor Drive System

A statistical model of noises at input port of inverter and its coupling to low voltage cable on fuel cell bus

Analysis of Cooling and Heating Characteristics of Thermal Management System for Fuel Cell Bus

Characteristics of Common-Mode Conducted Current in Electric Vehicle

System-Level Conducted EMI Model for SiC Powertrain of Electric Vehicles

Influence of System Layout on CM EMI Noise of SiC Electric Vehicle Powertrains

Effect of Common-Mode Interference on Communication Performance of a Motor Drive System

Analysis of Cable Parameters on the Real Chassis by Measurement