Abstract:Fuel cell vehicles have shown their advantages in clean run and high efficiency compared with the traditional internal combustion engine vehicles,but they would cause more serious EMC(Electromagnetic Compatibility) problems.So the EMC research about these new kinds of vehicles is being focused on.It is verified that the driving system on the fuel cell vehicle could generate high frequency disturbance for the switching of the IGBTs(Insulated gate bipolar transistors).This is one of the main conducted disturbances in fuel cell vehicle.High frequency circuit model of driving system is a very effective tool to research the transient response,which could help to reduce the related disturbance effect.This kind of model should include the time-variable parameters caused by the switching of the IGBTs and the frequency-variable parameters caused by the skin effect of the cables and the AC motor.In this paper,the fuel cell model and IGBTs model are set up based on the other's work.The frequency-variable parameters of the cables and the AC motor are measured on the real fuel cell bus.The vector fitting method is applied to fit the complex frequencyvariable parameters into rational form which could be transmitted into time-domain easily by convolution.Then the time-variable parameters and the frequency-variable parameters could be considered together in time domain.One advantage of this method is that it could avoid calculating a lot of frequency point as necessary in frequency domain method.Another is that it could be extended to consider more complex time-variable parameters of IGBTs.This method can save a lot of calculation time.The transient response is analyzed when one bridge of the inverter is switching.Simulation results fit well with the experimental data and this method is proved to be effective.

Statistical Analysis Of Conducted Disturbance Source In Fuel Cell Bus

Statistical Analysis of Conducted Disturbance Sources in the Driving System of Fuel Cell Bus

Characteristics Analysis of the Conducted Disturbance in the Driving System of Fuel Cell Bus

Investigation of conducted disturbance from driving system in fuel cell bus

Distribution and Characteristic of the Disturbances in the Driving System of a Fuel Cell Bus

Conductive electromagnetic interferences of a fuel cell bus

High Frequency Conducted Disturbance Analysis of Driving System in Fuel Cell Vehicle

Simulation on Conducted Disturbance in Driving System of Novel Fuel Cell Bus

Electromagnetic Conductive Interference Characteristics in Driving System of Fuel Cell Bus

A statistical model of noises at input port of inverter and its coupling to low voltage cable on fuel cell bus

Application and Study of Novel Electronic Technologies on Vehicle Control System of Fuel Cell Bus

Systematic Analysis of Conducted Electromagnetic Interferences for the Electric Drive System in Electric Vehicles

Test and Analysis of Conducted Disturbance Sources of the Truck Crane under Stable Conditions

Analysis of Cable Parameters on the Real Chassis by Measurement

Analysis and optimization of electromagnetic compatibility for electric vehicles

Performance Analysis of Proton-Exchange Membrane Fuel Cell Stacks Used in Beijing Urban-Route Buses Trial Project

Fuel cell system degradation analysis of a Chinese plug-in hybrid fuel cell city bus

Study on parameters matching of hybrid drivetrain system

Finite Element Analysis on the Side-impact Safety of Fuel Cell City Bus

Methodology of Designing Durability Test Protocol for Vehicular Fuel Cell System Operated in Soft Run Mode Based on Statistic Results of On-Road Data

Working Conditions Analysis and Performance Degradation Estimation of Fuel Cell Buses Based on Real Road Data