Abstract:The main objective of the present article is to obtain the optimum technological parameters of the automobile plastic front-end frame. Moldflow software was used to simulate the injection molding of the automobile plastic front-end frame bracket in this study. The uniformity experiment was designed and completed. Five injection molding process parameters, including mold temperature, melt temperature, packing pressure, injection time, and packing time, were selected as experimental factors. Volume shrinkage and warpage amount were selected as quality evaluation indexes. Statistical Product Service Solutions (SPSS) software was used to perform linear regression analysis on the test results, respectively, and the linear regression equation corresponding to the two evaluation indexes was obtained. Then, regression equation analysis was carried out to obtain the optimal process parameter combination of the volume shrinkage and the warpage amount. A back propagation (BP) neural network model with input as a process parameter and output as an evaluation index is established by MATLAB and optimized by a genetic algorithm (GA). Finally, the optimized neural network model was used to predict the combination of process parameters with the minimum volume shrinkage and warpage amount. Based on the performed simulations, the minimum volume shrinkage and the minimum amount of warping in the optimal design were 13% and 0.7062 mm, respectively. The corresponding combination of process parameters was the mold temperature of 75.5°C, the melt temperature of 285.32°C, the packing pressure of 42.32 MPa, the injection time of 3.45 s, and the packing time of 60 s. According to the optimal process parameters, the volume shrinkage and warpage amount of the automobile plastic front-end frame have reached the optimal state at the same time, which improves the quality of injection molding and reduces production and processing costs. It has a certain guiding significance.

Experimental research on injection molding shrinkage characteristics of plastic parts

Simulation and Experimental Analysis on Non-circular Cross-section Parts Residual Wall Thickness of Water-assisted Injection Molding

EXPERIMENTAL INVESTIGATION INTO MICRO INJECTION MOLDING OF PLASTIC PARTS

Investigation of Mold Temperature Affecting on Shrinkage of Rapid Heat Cycle Molding Plastic Part

Influence of gas counter pressure injection molding parameters on shrinkage ratio of plastic part

The influence of mold design and process parameters on dimensional shrinkage of perfluoroalkoxy alkane injection molding parts

Research on the Effects of Process Parameters on Shrinkage Variation of the Rapid Heat Cycle Molding Plastic Part

3D Simulation of Residual Thermal Stress and Shrinkage in Plastic Injection Molding

Measurement and Research on Deformation of Mold During Plastic Injection Molding

Research on Quality Characterization Method of Micro-Injection Products Based on Cavity Pressure

SHRINK AND DEFECT ANALYSIS OF HDPE THICK PART

Influence of process parameters and post-molding condition on shrinkage and warpage of injection-molded plastic parts with complex geometry

Research on the Application of Injection Molding Simulation Technology in Mold Design

Shrinkage and Warpage Mechanism of Overflow Water-Assisted Injection Molding Short Fiber-Reinforced Polymers

Influence of mold design and injection parameters on warpage deformation of thin-walled plastic parts

Effect of processing parameter changes on mechanical properties during injection molding: Amorphous versus semi‐crystalline materials

Investigation of the Effect of Molding Variables on Sink Marks of Plastic Injection Molded Parts Using Taguchi DOE Technique

Research on Optimization of Injection Molding Process Parameters of Automobile Plastic Front-End Frame

Experimental and numerical investigations on formation mechanisms of hollow structures in overflow water‐assisted injection‐molded parts of short‐glass‐fiber‐reinforced polypropylene

Analysis of the Warpage Phenomenon of Micro-Sized Parts with Precision Injection Molding by Experiment, Numerical Simulation, and Grey Theory

Calculation of injection molding shrinkage of plastic gears