Abstract:In polymer melt processing, the heat transfer coefficient (HTC) determines heat flux across the polymer/mould interface for both conventional and micro injection moulding (μIM), and is a key parameter in mould design and predictive computational simulations. However, values typically used in commercial software for injection moulding are usually obtained from large-scale experiments, which may be not appropriate for μIM. The present work introduces a novel experimental method for precisely determining the actual averaged HTC values in μIM. This method uses changeable mould inserts equipped with temperature and pressure sensors, positioned exactly at the same mould cavity location rather than at adjacent positions. The calculated HTC values obtained through this method are used subsequently in the simulation of μIM instead of software default values, following optimization of boundary conditions and mesh. This constitutes a significant addition to current knowledge in the field. The influence of injection velocity, packing pressure and mould temperature on HTC is studied. Experimentally calculated HTC values for the packing and cooling stages are approximately 8500W/m 2 K and 6300W/m 2 K, respectively. Based on process monitoring from short shot experiments, subsequent simulation of a 600μm thick part is predicted successfully using multi-scale finite element modelling. Wall slip and venting parameters are optimized using a one-factor-at-a-time method; a friction coefficient of 0 and no venting are found to be the optimal parameters for modelling wall slip and venting. Both are critical in simulations, although wall slip has a greater influence than venting on the simulation accuracy. The default and calculated HTC values are used in the simulations for comparison, while the simulations using the calculated HTC values were validated as being effective and accurate.

EXPERIMENTAL INVESTIGATION INTO MICRO INJECTION MOLDING OF PLASTIC PARTS

Effect of Micro-Mold Cavity Dimension on Structure and Property of Polylactic Acid/Polycaprolactone Blend under Microinjection Molding Conditions

Effect of Micro-Mold Cavity Dimension on Structure Andproperty of Polylactic Acid/Polycaprolactone Blend Undermicroinjection Molding Conditions

Injection molding and characterization of PMMA-based microfluidic devices

Evaluation of Vacuum Venting for Micro-injection Molding

Research on Quality Characterization Method of Micro-Injection Products Based on Cavity Pressure

Influence of injection air pressure on the microcapillary formation within extruded plastic films

Effect of processing parameter changes on mechanical properties during injection molding: Amorphous versus semi‐crystalline materials

Effect of processing parameters, antistiction coatings, and polymer type when injection molding microfeatures

Micro-nanostructured polymer surfaces using injection molding: A review

Investigation of Mold Temperature Affecting on Shrinkage of Rapid Heat Cycle Molding Plastic Part

Effect of Process Parameters in Rapid Heat Cycle Molding Produce on the Replication Fidelity of Plastic Part

Investigation of Product and Process Fingerprints for Fast Quality Assurance in Injection Molding of Micro-Structured Components

Experimental investigation of injection moulding using thermoplastic polyurethane

Intelligent Methods for the Process Parameter Determination of Plastic Injection Molding

Research on the Effects of Process Parameters on Shrinkage Variation of the Rapid Heat Cycle Molding Plastic Part

Analysis of the Warpage Phenomenon of Micro-Sized Parts with Precision Injection Molding by Experiment, Numerical Simulation, and Grey Theory

Precision injection moulding of micro components: Determination of heat transfer coefficient and precision process simulation

The Influential Effect of Molding Parameters on Quality of Part Manufactured by Rapid Heat Cycle Molding Technology

Influence of Mold Temperature in Rapid Heat Cycle Molding on Replication Capability of Plastic Parts

An Investigation to Reduce the Effect of Moisture on Injection-Molded Parts through Optimization of Plasticization Parameters