Abstract:In polymer melt processing, the heat transfer coefficient (HTC) determines heat flux across the polymer/mould interface for both conventional and micro injection moulding (μIM), and is a key parameter in mould design and predictive computational simulations. However, values typically used in commercial software for injection moulding are usually obtained from large-scale experiments, which may be not appropriate for μIM. The present work introduces a novel experimental method for precisely determining the actual averaged HTC values in μIM. This method uses changeable mould inserts equipped with temperature and pressure sensors, positioned exactly at the same mould cavity location rather than at adjacent positions. The calculated HTC values obtained through this method are used subsequently in the simulation of μIM instead of software default values, following optimization of boundary conditions and mesh. This constitutes a significant addition to current knowledge in the field. The influence of injection velocity, packing pressure and mould temperature on HTC is studied. Experimentally calculated HTC values for the packing and cooling stages are approximately 8500W/m 2 K and 6300W/m 2 K, respectively. Based on process monitoring from short shot experiments, subsequent simulation of a 600μm thick part is predicted successfully using multi-scale finite element modelling. Wall slip and venting parameters are optimized using a one-factor-at-a-time method; a friction coefficient of 0 and no venting are found to be the optimal parameters for modelling wall slip and venting. Both are critical in simulations, although wall slip has a greater influence than venting on the simulation accuracy. The default and calculated HTC values are used in the simulations for comparison, while the simulations using the calculated HTC values were validated as being effective and accurate.

Evaluation of Vacuum Venting for Micro-injection Molding

Comparison of Tooling Materials in Injection Molding of Microscale Features

EXPERIMENTAL INVESTIGATION INTO MICRO INJECTION MOLDING OF PLASTIC PARTS

Effect of processing parameters, antistiction coatings, and polymer type when injection molding microfeatures

Printing Depth Modeling, Printing Process Quantification and Quick-Decision of Printing Parameters in Micro-Vat Polymerization

Influence of injection air pressure on the microcapillary formation within extruded plastic films

Surface Features of Polymer and Ceramic Microstructured Parts Manufactured by Micro Injection Molding

Evaluation of the vacuum infusion process objectives at the early stages of computer simulation

Development of Replica Molding Processes for Hypervariable Microstructural Components

Characterization of Stereolithography Printed Soft Tooling for Micro Injection Molding

Micro-nanostructured polymer surfaces using injection molding: A review

Ultrasonic plasticization micro-injection molding technology: characterization of replication fidelity and wettability of high-depth microstructure

Analysis of the Effects on the Quality of Micro Injection Molded Products

Effect of Micro-Mold Cavity Dimension on Structure and Property of Polylactic Acid/Polycaprolactone Blend under Microinjection Molding Conditions

Fabrication of Plastic Micro Features on Microporous Mold by Hot Embossing

Effect of Micro-Mold Cavity Dimension on Structure Andproperty of Polylactic Acid/Polycaprolactone Blend Undermicroinjection Molding Conditions

Research on the Cast Molding Process for High Quality PDMS Molds

Characterization of process and machine dynamics on the precision replication of microlens arrays using microinjection moulding

An Enhanced Vacuum-Assisted Resin Transfer Molding Process and Its Pressure Effect on Resin Infusion Behavior and Composite Material Performance

Precision injection moulding of micro components: Determination of heat transfer coefficient and precision process simulation

Investigation of micro-injection molding based on longitudinal ultrasonic vibration core.