Abstract:<p>The injection molding process is widely used for the mass production of plastic parts. However, as product designs become lighter, thinner and smaller, and the allowable tolerances shrink, the need to improve the quality consistency of the injection molding process has emerged as a critical concern. In mass production, injection molding is typically performed using fixed settings of the machine inputs. However, in practice, the properties of the plastic melt invariably change from batch to batch and even from shot to shot. Consequently, the use of fixed parameter settings fails to guarantee the stability of the molded part quality. Existing quality monitoring and control systems for the injection molding process are often based on pressure information. However, obtaining this information generally requires the installation of pressure sensors within the molding cavity, which is not only expensive and time-consuming, but may also interfere with the injection molding process itself. Accordingly, the present study proposes a quality monitoring and control system for injection molding processes based on the tie bar elongation measurements obtained using a strain gage. In the proposed approach, variations in the tie bar strain characteristic are taken to indicate deviations in the process stability and are used to manipulate the processing parameters accordingly in order to ensure the stability and consistency of the molded part quality. The feasibility of the proposed approach is demonstrated by performing injection molding trials with a two-cavity mold designed to produce tensile test specimens. The experimental results show that the quality of the molded parts varies significantly with the injection speed, velocity-to-pressure (V/P) switchover point, holding pressure, and melt temperature. Among these four parameters, the V/P switchover point and holding pressure induce a particularly rapid dynamic response, and thus provide an effective means of compensating for process deviations from shot to shot. By changing the melt temperature to simulate environmental noise, it is shown that the two parameter settings enable the consistency of the part weight to be restored to a range of 0.01 g within six shots. Moreover, the yield rate is enhanced from 60% to 90%.</p>

The Influential Effect of Molding Parameters on Quality of Part Manufactured by Rapid Heat Cycle Molding Technology

Influence of Large Framed Mold Placement in Autoclave on Heating Performance

Influence of Mold Temperature in Rapid Heat Cycle Molding on Replication Capability of Plastic Parts

Effect of Process Parameters in Rapid Heat Cycle Molding Produce on the Replication Fidelity of Plastic Part

Research on the Effects of Process Parameters on Shrinkage Variation of the Rapid Heat Cycle Molding Plastic Part

Investigation of Mold Temperature Affecting on Shrinkage of Rapid Heat Cycle Molding Plastic Part

An Efficient Thermal Cure Profile Design Method for Autoclave Curing of Large Size Mold

Research on Optimization of Injection Molding Process Parameters of Automobile Plastic Front-End Frame

Macro-effect of process parameter on waspage of rapid heat cycle molding plastic part

Optimization of Control Parameters in Micro Hot Embossing

Application of Intelligent Modeling Method to Optimize the Multiple Quality Characteristics of the Injection Molding Process of Automobile Lock Parts

Effect of processing parameter changes on mechanical properties during injection molding: Amorphous versus semi‐crystalline materials

Investigation of the Effect of Molding Variables on Sink Marks of Plastic Injection Molded Parts Using Taguchi DOE Technique

Enhancing the quality stability of injection molded parts by adjusting V/P switchover point and holding pressure

Multi-objective Robust Optimization of Injection Molding Process Parameters Based on TOPSIS

Parameter analysis of multi-objective optimization for energy efficiency and multiple quality aspects in injection molding

Effect of rapid heating cycle injection mold temperature on crystal structures, morphology of polypropylene and surface quality of plastic parts

Multi-Variable Interaction Analysis and A Proposed Quality Control System for Thermoplastics Injection Molding

Study on Processing Parameters of Ceramic Injection Moulding

Out-of-Mold Sensor-Based Process Parameter Optimization and Adaptive Process Quality Control for Hot Runner Thin-Walled Injection-Molded Parts

Mold design and forming process parameters optimization for passenger vehicle front wing plate