Abstract:In polymer melt processing, the heat transfer coefficient (HTC) determines heat flux across the polymer/mould interface for both conventional and micro injection moulding (μIM), and is a key parameter in mould design and predictive computational simulations. However, values typically used in commercial software for injection moulding are usually obtained from large-scale experiments, which may be not appropriate for μIM. The present work introduces a novel experimental method for precisely determining the actual averaged HTC values in μIM. This method uses changeable mould inserts equipped with temperature and pressure sensors, positioned exactly at the same mould cavity location rather than at adjacent positions. The calculated HTC values obtained through this method are used subsequently in the simulation of μIM instead of software default values, following optimization of boundary conditions and mesh. This constitutes a significant addition to current knowledge in the field. The influence of injection velocity, packing pressure and mould temperature on HTC is studied. Experimentally calculated HTC values for the packing and cooling stages are approximately 8500W/m 2 K and 6300W/m 2 K, respectively. Based on process monitoring from short shot experiments, subsequent simulation of a 600μm thick part is predicted successfully using multi-scale finite element modelling. Wall slip and venting parameters are optimized using a one-factor-at-a-time method; a friction coefficient of 0 and no venting are found to be the optimal parameters for modelling wall slip and venting. Both are critical in simulations, although wall slip has a greater influence than venting on the simulation accuracy. The default and calculated HTC values are used in the simulations for comparison, while the simulations using the calculated HTC values were validated as being effective and accurate.

Study on Processing Parameters of Ceramic Injection Moulding

EFFECT OF PRESSURE ON COLLOIDAL INJECTION MOULDING OF CERAMICS

On the Defects in Injection-Moulded Technical Ceramics

The Influence of Mold Pressing Parameters on Ptc of Hdpe/Cb Composites

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

The Influences of Solid Loading and Molding Variables on Alumina Injection Molding

The Influential Effect of Molding Parameters on Quality of Part Manufactured by Rapid Heat Cycle Molding Technology

Study on Computer Simulation of Co-injection Molding

Effect Of Molding Pressure On Structural And Densification Behavior Of Microwave-Sintered Ceramic Tool Material

Computer Simulation Analysis of Ceramic Powder Injection Molding Process and Molding Defects Formation

Progress of ceramic injection molding

Research on Quality Characterization Method of Micro-Injection Products Based on Cavity Pressure

Research on the Effects of Process Parameters on Shrinkage Variation of the Rapid Heat Cycle Molding Plastic Part

Effect of different processing parameters on interfacial heat-transfer behavior in high-pressure die-casting process

Influence of Casting Temperature and Mold Preheating Temperature on Centrifugal Casting by Numerical Simulation

Precise Injection Moulding of Advanced Ceramics

Effect of rapid heating cycle injection mold temperature on crystal structures, morphology of polypropylene and surface quality of plastic parts

PRECISE INJECTION MOLDING OF ADVANCED CERAMICS

Study on Melt Temperature Homogeneity in Injection Molding

Precision injection moulding of micro components: Determination of heat transfer coefficient and precision process simulation

Effect of processing parameter changes on mechanical properties during injection molding: Amorphous versus semi‐crystalline materials