Abstract:Soaking time and loading rate are the two important process parameters for semi-solid powder forming, which are next only to powder temperature. However, there have been few investigations on the influence of soaking time and loading rate on the semi-solid compression of porous material, which is an effective method for studying the deformation characteristics of semi-solid materials and is widely used to optimize the semi-solid forming processes. Therefore, the microstructures, grain size and shape factor, liquid fraction, relative densities and stress–strain curves of Al-4Cu-Mg alloy with a porosity of 30% compacted at different soaking time and loading rates were measured, and the strain rate sensitivity coefficient, the relationship between peak stresses and strain rates, and the processing map were calculated and analyzed. The results indicate that as the soaking time increases, the particle grows and the liquid fraction increases slightly, and the liquid distribution changes from dots in grains to concentrating on grain boundaries in powders, making the relative density increase basically and the peak stress decrease firstly and then increase slowly. Thus, the most suitable soaking time for semi-solid compression is 2 to 5 min. With the loading rate increasing, the particle size reduces first and then increases, the relative density decreases, while the peak stress basically raises, combining the action of powder breakage, grain coarsening and liquid flowing. The peak stress basically has a power relationship with the strain rate, and the processing map can be used to analyze porous semi-solid materials, which are verified to be consistent with the experimental results. Therefore, the optimal semi-solid forming parameters of Al-4Cu-Mg alloy powders are at a deformation rate ranging from 0.6 to 6 mm/s and at a temperature of 860 to 873 K.

The Influences of Solid Loading and Molding Variables on Alumina Injection Molding

Plastic Deformation and Sintering of Alumina under High Pressure

Pressureless Sintering Behavior of Injection Molded Alumina Ceramics

Injection molding of surface modified powders with high solid loadings: A case for fabrication of translucent alumina ceramics

Integrated Numerical Simulations and Experimental Measurements for the Sintering Process of Injection-Molded Ti-6Al-4V Alloy

Influences of Process Parameters on Mechanical Properties of ABS/Aluminum Powder Blending Products

Influence of Soaking Time and Loading Rate on Semi-solid Compression of Porous Al-4Cu-Mg Alloy

Study on Processing Parameters of Ceramic Injection Moulding

Influence of sintering temperature and CVI time on mechanical properties of 3D-printed alumina ceramics

Influence of Particle Size Distributions with Various Geometrical Standard Deviations on Slip-Cast Forming and Sintering Behavior in Submicron Alumina Powder Compacts

Effect Of Molding Pressure On Structural And Densification Behavior Of Microwave-Sintered Ceramic Tool Material

Study on the influence of in-mold sequential injection molding process parameters on mechanical properties of self-reinforced single composites

Influence of the Compacts Homogeneity on the Incidence of Cracks During Thermal Debinding in Ceramic Injection Molding

Effects of the Binder Compositions on the Homogeneity of Ceramic Injection Molded Compacts

Microstructure and properties of zirconia-alumina composites fabricated via powder injection molding

Preparation and Sintering Properties of Alumina Slurries with High Solid Loading

Effects of particle size distribution and sintering temperature on properties of alumina mold material prepared by stereolithography

Influencing factors on Al2O3 instant-solidifying forming process

Study on the Influence of Injection Velocity on the Evolution of Hole Defects in Die-Cast Aluminum Alloy

The Effect of Aluminium Injection Parameters on the Mechanical Properties of the Material Produced by High Pressure Die-Casting

Injection molding of ultra-fine zirconia (Y-TZP) powders