Abstract:<p>The injection molding process is widely used for the mass production of plastic parts. However, as product designs become lighter, thinner and smaller, and the allowable tolerances shrink, the need to improve the quality consistency of the injection molding process has emerged as a critical concern. In mass production, injection molding is typically performed using fixed settings of the machine inputs. However, in practice, the properties of the plastic melt invariably change from batch to batch and even from shot to shot. Consequently, the use of fixed parameter settings fails to guarantee the stability of the molded part quality. Existing quality monitoring and control systems for the injection molding process are often based on pressure information. However, obtaining this information generally requires the installation of pressure sensors within the molding cavity, which is not only expensive and time-consuming, but may also interfere with the injection molding process itself. Accordingly, the present study proposes a quality monitoring and control system for injection molding processes based on the tie bar elongation measurements obtained using a strain gage. In the proposed approach, variations in the tie bar strain characteristic are taken to indicate deviations in the process stability and are used to manipulate the processing parameters accordingly in order to ensure the stability and consistency of the molded part quality. The feasibility of the proposed approach is demonstrated by performing injection molding trials with a two-cavity mold designed to produce tensile test specimens. The experimental results show that the quality of the molded parts varies significantly with the injection speed, velocity-to-pressure (V/P) switchover point, holding pressure, and melt temperature. Among these four parameters, the V/P switchover point and holding pressure induce a particularly rapid dynamic response, and thus provide an effective means of compensating for process deviations from shot to shot. By changing the melt temperature to simulate environmental noise, it is shown that the two parameter settings enable the consistency of the part weight to be restored to a range of 0.01 g within six shots. Moreover, the yield rate is enhanced from 60% to 90%.</p>

Study on Melt Temperature Homogeneity in Injection Molding

Influence of Large Framed Mold Placement in Autoclave on Heating Performance

Effect on Residual Wall Thickness of Parts with Floating Core Injection of Water-Assisted Injection Molding

Study on Processing Parameters of Ceramic Injection Moulding

Integrated Numerical Simulations and Experimental Measurements for the Sintering Process of Injection-Molded Ti-6Al-4V Alloy

Influence of Injection Molding Conditions on Residual Stress in Sandwich Parts

Influence of Casting Temperature and Mold Preheating Temperature on Centrifugal Casting by Numerical Simulation

A Heat-Balance Method for Autoclave Process of Composite Manufacturing

Melt Temperature Profile Prediction for Thermoplastic Injection Molding

Effect of rapid heating cycle injection mold temperature on crystal structures, morphology of polypropylene and surface quality of plastic parts

Study on Computer Simulation of Co-injection Molding

Numerical Study of Heat Transfer and Temperature in the Screw Groove for Molten Plastic

Enhancing the quality stability of injection molded parts by adjusting V/P switchover point and holding pressure

Influence of Mold Temperature in Rapid Heat Cycle Molding on Replication Capability of Plastic Parts

Effect of Process Parameters in Rapid Heat Cycle Molding Produce on the Replication Fidelity of Plastic Part

Transition from the Hierarchical Distribution to a Homogeneous Formation in Injection Molded Isotactic Polypropylene (ipp) with Dynamic Mold Temperature Control

Study of Performance of Novel Injection Screw

Study on the influence of in-mold sequential injection molding process parameters on mechanical properties of self-reinforced single composites

The Influential Effect of Molding Parameters on Quality of Part Manufactured by Rapid Heat Cycle Molding Technology

Study on the Heat Transfer at the Casting-Mould Interface in Resin-Bonded Sand Mould Casting of Mg-Gd-Y-Zr Alloy

The Influences of Solid Loading and Molding Variables on Alumina Injection Molding