Effect on Residual Wall Thickness of Parts with Floating Core Injection of Water-Assisted Injection Molding

DING Jia-xin,CHEN Ying-long,ZHOU Hua

DOI: https://doi.org/10.3785/j.issn.1008-973x.2017.05.013

2017-01-01

Abstract:A residual wall thickness analysis method based on computational fluid dynamics (CFD) was proposed for the difference in residual wall thickness of parts with different injection methods of water-assisted injection molding (WAIM).According to the flow characteristics of water and high-temperature plastic melt in process of WAIM,the two-phase flow CFD model of floating core injection and direct injection was established respectively for the numerical simulation of forming process of residual wall thickness.The numerical simulation results were compared with experimental results,and the distribution of residual wall thickness was analyzed.Results show that the numerical simulation agreed with the experimental results,verifying the validity of CFD model.Compared with the direct injection,the floating core injection can control residual wall thickness of parts,and its size is less affected by delay time.The shorter the delay time is,the closer to the ideal control residual wall thickness is.Difference in internal and external wall thickness with floating core injection is smaller than that with direct injection in curve parts,improving parts mechanical property.