Abstract:The main objective of the present article is to obtain the optimum technological parameters of the automobile plastic front-end frame. Moldflow software was used to simulate the injection molding of the automobile plastic front-end frame bracket in this study. The uniformity experiment was designed and completed. Five injection molding process parameters, including mold temperature, melt temperature, packing pressure, injection time, and packing time, were selected as experimental factors. Volume shrinkage and warpage amount were selected as quality evaluation indexes. Statistical Product Service Solutions (SPSS) software was used to perform linear regression analysis on the test results, respectively, and the linear regression equation corresponding to the two evaluation indexes was obtained. Then, regression equation analysis was carried out to obtain the optimal process parameter combination of the volume shrinkage and the warpage amount. A back propagation (BP) neural network model with input as a process parameter and output as an evaluation index is established by MATLAB and optimized by a genetic algorithm (GA). Finally, the optimized neural network model was used to predict the combination of process parameters with the minimum volume shrinkage and warpage amount. Based on the performed simulations, the minimum volume shrinkage and the minimum amount of warping in the optimal design were 13% and 0.7062 mm, respectively. The corresponding combination of process parameters was the mold temperature of 75.5°C, the melt temperature of 285.32°C, the packing pressure of 42.32 MPa, the injection time of 3.45 s, and the packing time of 60 s. According to the optimal process parameters, the volume shrinkage and warpage amount of the automobile plastic front-end frame have reached the optimal state at the same time, which improves the quality of injection molding and reduces production and processing costs. It has a certain guiding significance.

Investigation of Mold Temperature Affecting on Shrinkage of Rapid Heat Cycle Molding Plastic Part

Research on the Effects of Process Parameters on Shrinkage Variation of the Rapid Heat Cycle Molding Plastic Part

Influence of Mold Temperature in Rapid Heat Cycle Molding on Replication Capability of Plastic Parts

Effect of Process Parameters in Rapid Heat Cycle Molding Produce on the Replication Fidelity of Plastic Part

Influence of Large Framed Mold Placement in Autoclave on Heating Performance

The Influential Effect of Molding Parameters on Quality of Part Manufactured by Rapid Heat Cycle Molding Technology

An Efficient Thermal Cure Profile Design Method for Autoclave Curing of Large Size Mold

The Influences of Cooling Rate on Shrink and Shrinkage Formation of HDPE Thick Parts

Macro-effect of process parameter on waspage of rapid heat cycle molding plastic part

Effect of rapid heating cycle injection mold temperature on crystal structures, morphology of polypropylene and surface quality of plastic parts

SHRINK AND DEFECT ANALYSIS OF HDPE THICK PART

Influence of process parameters and post-molding condition on shrinkage and warpage of injection-molded plastic parts with complex geometry

Influence of gas counter pressure injection molding parameters on shrinkage ratio of plastic part

EXPERIMENTAL INVESTIGATION INTO MICRO INJECTION MOLDING OF PLASTIC PARTS

An Investigation to Reduce the Effect of Moisture on Injection-Molded Parts through Optimization of Plasticization Parameters

A Heat-Balance Method for Autoclave Process of Composite Manufacturing

Research on Optimization of Injection Molding Process Parameters of Automobile Plastic Front-End Frame

The influence of mold design and process parameters on dimensional shrinkage of perfluoroalkoxy alkane injection molding parts

Effect of processing parameter changes on mechanical properties during injection molding: Amorphous versus semi‐crystalline materials

Numerical investigation of the effect of thermal gradients on curing performance of autoclaved laminates

Thermoset characterization for moldability analysis