Abstract:This article presents a fully differential high-dynamic-range direct-conversion receiver for sub-1-GHz band applications in a 180-nm CMOS technology. The integrated self-adaptive multipart automatic gain control (AGC) loops are designed to cope with large input signal. In the radio frequency (RF) domain, a gain-adjustable noise-canceling balun low-noise amplifier (LNA) and a high-linearity RF variable gain amplifier (VGA) are co-designed to keep a steady differential output power for the mixer stage. In baseband (BB), a novel gain distribution method is proposed to protect BB circuits from saturation. To prove the concept, one of the most typical and strict application scenarios in the sub-1-GHz band, digital television (DTV) standard, is analyzed and chosen as the design target. The receiver achieves a noise figure (NF) of 3.6–4.6 dB in the ultrahigh-frequency (UHF) band. A wide gain tuning range of 128.8 dB is realized in this work, featuring fully integrated AGC loops. The programmable bandwidth of the low-pass filter (LPF) can be adjusted from 1 to 4 MHz, supporting 2-/6-/7-/8-MHz signal channels. The maximum in-band third-order input-referred intercept point (IIP3) is 10 dBm under the conversion gain of 0 dB. The receiver consumes 49.56 mA from a 1.8-V voltage supply and occupies an area of 3.56 mm2.

A Direct Conversion WLAN Receiver

A compact dual-band direct-conversion CMOS transceiver for 802.11a/b/g WLAN

A Low Noise, High Linearity CMOS Receiver for 802. 11b WLAN Applications

A 0.1-1.9Ghz 65nm CMOS Variable-Gain Mixer-First Receiver with DSA and Noise-Shaping TIA.

A High Performance 2-Ghz Direct-Conversion Front End with Single-Ended RF Input in 0.13 Um CMOS

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A 1 GHz CMOS RF front-end IC for a direct-conversion wireless receiver

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

An Optimized Receiver RF Front-End

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

High-Linearity Direct Conversion Receiver with the Transconductance Equalization Technique and DCOC Method

An 8mw Ultra Low Power 60ghz Direct-Conversion Receiver with 55db Gain and 4.9db Noise Figure in 65nm CMOS

A 1.65 Mw Direct-Conversion Receiver for UHF RFID Readers

A Direct Conversion WiMAX RF Receiver Front-End in CMOS Technology

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A 2.4-Ghz Fully CMOS Integrated Transmitter for 802.1lb Wireless LAN

A Dual-Band Reconfigurable Direct-Conversion Receiver Rf Front-End

A Low-Power Monolithic Reconfigurable Direct-Conversion Receiver RF Front-End for 802.11a/b/g Applications