Abstract:With the aim to enhance the phase shift range and bandwidth of the novel Inverted-E topology for single-bit and multi-bit phase shifters, this work proposes a new structure, wherein the Main Transmission Line (MTL) in the Inverted-E topology is replaced by a tunable transmission line with a fixed open circuited stub loaded at its center point. Therefore, offering four design freedoms, precisely the characteristic impedances and electrical lengths of the transmission line and the fixed open circuited stub, that provides it the flexibility to achieve much smaller susceptance values for large phase shifts up to 180°. The required susceptances are realized using three symmetric open or short-circuited stubs, which are loaded to the tunable transmission line using switching p-i-n diodes. The fixed open circuited stubs ensure excellent circuit matching to the port impedance of in the OFF-state, without the need of any additional matching network. Whereas, the enhanced design flexibility enables the realization of compact dimensions and lower insertion loss. A systematic design procedure is developed, supported by detailed design theory and mathematical formulations, followed by validation through analysis and simulations of typical 22.5°, 45°, 90° and 180° digital phase shifters. For experimental verifications, 90° and 180° designs are manufactured at center frequency of 2.4 GHz and a good agreement is observed with theory and simulations. The results indicate compact dimensions of and , corresponding insertion losses of 1.7 dB and 2.85 dB with phase error less than 1° at center frequency. Moreover, the phase variation is observed to be 2° and 5°, in bandwidths of 400 MHz and 100 MHz respectively.

A Bulk Micromachined Mems Digital Distributed Phase Shifter Based On Metal-Air-Metal Capacitors Formed By Intrinsic Stress

A Bulk Micromachined Distributed Digital Microwave Phase Shifter with Butterfly Multilayer Bridges and MAM Capacitors

A Bulk Micromachined Distrubuted Digital Phase Shifter for Microwave Phased Array Applications

Design and analysis of a bulk micromachined distributed digital microwave phase shifter on glass substrate

An Ultra Broadband Passive Vector Modulator Phase Shifter

Fabrication And Characterization Of A Novel Bulk Si Micromachined Distributed Microwave Phase Shifter

A DMTL Phase Shifter Using Insulation Layer and Saw-Shaped CPW

A Novel Design Of Rf-Mems Phase Shifter Based On Bridge-Like Coplanar Waveguide

A Novel Design for the Miniaturization of the DMTL Phase Shifter

A Wafer-Scale Packaging for RF DMTL Phase Shifter

MEMS phase shifter based on capacitance-inductance phase shift units

Design of RF MEMS Phase Shifter Based on Saw-Shaped CPW

Notice of Violation of IEEE Publication PrinciplesKa-band Distributed MEMS Phase Shifters on Silicon Using AlSi Suspended Membrane

A Ka-band 0/Π MEMS Phase Shifter

A Ka-band 0/∏ MEMS phase shifter

Inverted-E Type Phase Shifter Using Fixed Stub-Loaded Main Line: Enhanced Bandwidth and Phase Shift Range

Wafer Level Micropackaging for Distributed Mems Phase Shifters

A 1.7–2.7-GHz 4-bit Phase shifter based on packaged RF MEMS switches

Electromechanical Design of Low-Driven Voltage Capacitive Switches Based on Ka-Bank Distributed MEMS Phase Shifters

A Compact 5-bit Switched-line Digital MEMS Phase Shifter

A 4-Bit Switched-Line Phase Shifter Based on MEMS Switches