Abstract:With the aim to enhance the phase shift range and bandwidth of the novel Inverted-E topology for single-bit and multi-bit phase shifters, this work proposes a new structure, wherein the Main Transmission Line (MTL) in the Inverted-E topology is replaced by a tunable transmission line with a fixed open circuited stub loaded at its center point. Therefore, offering four design freedoms, precisely the characteristic impedances and electrical lengths of the transmission line and the fixed open circuited stub, that provides it the flexibility to achieve much smaller susceptance values for large phase shifts up to 180°. The required susceptances are realized using three symmetric open or short-circuited stubs, which are loaded to the tunable transmission line using switching p-i-n diodes. The fixed open circuited stubs ensure excellent circuit matching to the port impedance of in the OFF-state, without the need of any additional matching network. Whereas, the enhanced design flexibility enables the realization of compact dimensions and lower insertion loss. A systematic design procedure is developed, supported by detailed design theory and mathematical formulations, followed by validation through analysis and simulations of typical 22.5°, 45°, 90° and 180° digital phase shifters. For experimental verifications, 90° and 180° designs are manufactured at center frequency of 2.4 GHz and a good agreement is observed with theory and simulations. The results indicate compact dimensions of and , corresponding insertion losses of 1.7 dB and 2.85 dB with phase error less than 1° at center frequency. Moreover, the phase variation is observed to be 2° and 5°, in bandwidths of 400 MHz and 100 MHz respectively.

Distributed Ferroelectric Phase Shifter with Slots Periodically Inserted into Ground

Improved Ferroelectric Phase Shifter by Inserting Spiral Inductors into Ground

Planar Tunable High-Temperature Superconductor Microwave Broadband Phase Shifter with Patterned Ferroelectric Thin Film

Modified principle of distributed ferroelectric phase shifter considering the influence of interconnecting lines

An Ultra Broadband Passive Vector Modulator Phase Shifter

A Novel Dieletric Slot Stripline Structure for Millimeter Wave Flexible Printed Circuit

Broadband Nonreciprocal Spoof Plasmonic Phase Shifter Based on Transverse Faraday Effects

29-/35 GHz Dual-band High-Gain Phase Shifter with Hybrid -Networks

A Novel Schiffman Phase Shifter with A Defected Microstrip Structure

Novel Phase Shifters Using Short-Circuited Cross-Slotted Patch Resonator

Reflective Liquid-Crystal Phase Shifter based on Periodically Loaded Differential Microstrip Lines

Inverted-E Type Phase Shifter Using Fixed Stub-Loaded Main Line: Enhanced Bandwidth and Phase Shift Range

A New Wide-Band 180&#x00b0; Planar Phase Shifter Network

A Bulk Micromachined Distrubuted Digital Phase Shifter for Microwave Phased Array Applications

A Digital Siw Phase Shifter Implemented by Switching Transverse Slots Via Pin Diodes

A Bulk Micromachined Mems Digital Distributed Phase Shifter Based On Metal-Air-Metal Capacitors Formed By Intrinsic Stress

Design and analysis of a bulk micromachined distributed digital microwave phase shifter on glass substrate

A COMPACT PHASE SHIFTER WITH WIDE PHASE RANGE USING LOADED TRANSMISSION LINE

A New Broadband Differential Phase Shifter Fabricated Using a Novel CRLH Structure

Equivalent Circuit of Low- Thickness Liquid Crystal Phase Shifter with Slow Wave Structure

A DMTL Phase Shifter Using Insulation Layer and Saw-Shaped CPW