Abstract:With the aim to enhance the phase shift range and bandwidth of the novel Inverted-E topology for single-bit and multi-bit phase shifters, this work proposes a new structure, wherein the Main Transmission Line (MTL) in the Inverted-E topology is replaced by a tunable transmission line with a fixed open circuited stub loaded at its center point. Therefore, offering four design freedoms, precisely the characteristic impedances and electrical lengths of the transmission line and the fixed open circuited stub, that provides it the flexibility to achieve much smaller susceptance values for large phase shifts up to 180°. The required susceptances are realized using three symmetric open or short-circuited stubs, which are loaded to the tunable transmission line using switching p-i-n diodes. The fixed open circuited stubs ensure excellent circuit matching to the port impedance of in the OFF-state, without the need of any additional matching network. Whereas, the enhanced design flexibility enables the realization of compact dimensions and lower insertion loss. A systematic design procedure is developed, supported by detailed design theory and mathematical formulations, followed by validation through analysis and simulations of typical 22.5°, 45°, 90° and 180° digital phase shifters. For experimental verifications, 90° and 180° designs are manufactured at center frequency of 2.4 GHz and a good agreement is observed with theory and simulations. The results indicate compact dimensions of and , corresponding insertion losses of 1.7 dB and 2.85 dB with phase error less than 1° at center frequency. Moreover, the phase variation is observed to be 2° and 5°, in bandwidths of 400 MHz and 100 MHz respectively.

Improved Ferroelectric Phase Shifter by Inserting Spiral Inductors into Ground

Distributed Ferroelectric Phase Shifter with Slots Periodically Inserted into Ground

Planar Tunable High-Temperature Superconductor Microwave Broadband Phase Shifter with Patterned Ferroelectric Thin Film

29-/35 GHz Dual-band High-Gain Phase Shifter with Hybrid -Networks

Hybrid broadband high-precision phase shifter integrated circuit

Modified principle of distributed ferroelectric phase shifter considering the influence of interconnecting lines

Improved Technique of H-Plane Nonreciprocal Ferrite Phase Shifter

A DMTL Phase Shifter Using Insulation Layer and Saw-Shaped CPW

Design and Optimization of Diamond Mid-Infrared Phase Shifter

FERRITE-LOADED HALF MODE SUBSTRATE INTEGRATED WAVEGUIDE PHASE SHIFTER

A New Wide-Band 180&#x00b0; Planar Phase Shifter Network

Inverted-E Type Phase Shifter Using Fixed Stub-Loaded Main Line: Enhanced Bandwidth and Phase Shift Range

Liquid Crystal-Filled 60 GHz Coaxially Structured Phase Shifter Design and Simulation with Enhanced Figure of Merit by Novel Permittivity-Dependent Impedance Matching

Compact and Low Loss Phase Shifter with Low Bias Field Using Partially Magnetized Ferrite

Design of wideband 90° phase shifter using compact CRLH structure

Reflective Liquid-Crystal Phase Shifter based on Periodically Loaded Differential Microstrip Lines

Compact Wideband Phase Shifter Using Microstrip Self-Coupled Line and Broadside-Coupled Microstrip/CPW for Multiphase Feed-Network

Novel Compact and Low-Loss Phase Shifters With Magnetodielectric Disturber

A Ka-band 3-bit RF MEMS switched line phase shifter implemented in coplanar waveguide

A COMPACT PHASE SHIFTER WITH WIDE PHASE RANGE USING LOADED TRANSMISSION LINE

MEMS phase shifter based on capacitance-inductance phase shift units