Abstract:Thin-walled tubes are widely used as energy absorption components in vehicle crashworthiness design where axial crushing is one of the most typical loading conditions. Lightweight materials such as high-strength steel, aluminum and magnesium have been applied for thin-walled tubes for weight reduction. Meanwhile, most of these lightweight materials are more brittle and easily fractured than traditional steel. Distribution and history of stress triaxiality and equivalent strain in the thin-walled tubes under axial crushing have been analyzed in this article with finite element simulation, as these two parameters of stress and strain states are commonly used for constructing fracture locus of materials. It is observed that both stress triaxiality and equivalent strain are transferring along the tube length like waves. Analysis results show that fracture is more likely to take place on the edge than the other positions of square thin-walled tubes. For identical axial crushing stroke, there is little difference of stress and strain states inside the square thin-walled tubes with initial impact velocity varying from 6m/s to 24m/s. Influence of geometrical parameters on the stress and strain states have also been analyzed, including the shape of cross-section corner, the wall thickness and the shape of cross-section, respectively. Analysis results in this article may offer references for design of thin-walled tubes and the necessary experimental characterization of mechanical properties for lightweight materials.

Computer Simulation for Tube Crushing

Simulation and Analysis of UOE Pipe Production Processing by Three-Dimensional Finite Element Method

SIMULATION ANALYSIS OF RESIDUAL STRESS FOR COLD STRAIGHTENING P110 CASING

Theoretical and numerical study on axial crush of new extruded multi-cell tube

Numerical Simulation of Fracture and Damage Behaviour of Concrete at Different Ages

3D Finite Element Simulation of Complex Static and Dynamic Fracture in Quasi-Brittle Materials

Experimental study on centrifuge concrete filled thin-walled steel tubular components under the action of torsion

3D Simulation of Rotary Swaging Process for Thin-Walled Tube

Finite element modeling of the quasi-static axial crushing of braided composite tubes

3D Rigid–plastic FEM Numerical Simulation on Tube Spinning

Behaviour of Tube under Axial Crush Load with Considering Effect of Heat Exchanged

Study on the Crushing and Hydroforming Processes of Tubes in a Trapezoid-Sectional Die

Cfd Simulation Of Cracking Tube With Internal Twisted Slices

Study on Numerical Simulation for Control of Winding Process of Thin Wall Spiral Tube

Numerical Simulation and Sensitivity Analysis for Tube Hydropiercing Quality Based on Experiments

Numerical simulation of expansion process of soundless cracking demolition agents by coupling finite difference and discrete element methods

Mechanical behavior of Ti-6Al-4V lattice-walled tubes under uniaxial compression

Numerical Simulation of Temperature Field and Stress Field for and Axial Crack Analysis of Heavy-wall Centrifugally Cast Hollow Bloom

Evaluation of the Stress-Strain State at the Crack Tip in Casing Pipes Based on Numerical Simulation

Research and Application Prospect of Computer Simulation on Heat Treatment Process

On the Fracture Possibility of Thin-Walled Tubes under Axial Crushing