Abstract:Nonuniform temperature fields in steam cracking furnaces caused by geometry factors such as burner positions, shadow effects, and asymmetry of the reactor coil layout are detrimental for product yields and run lengths. The techniques of adjusting burner firing (zone firing) and feedstock mass flow rate (pass balancing) have been practiced industrially to mitigate these effects but could only reduce the nonuniformities between the so‐called modules (a group of many coils). An extension of the pass balancing methodology is presented to further minimize the intra‐module nonuniformities, that is, variation between the coils within a module, in floor fired furnaces. Coupled furnace‐reactor computational fluid dynamics‐based simulations of an industrial ultraselective conversion (USC) furnace were performed to evaluate four different feedstock flow distribution schemes, realizing equal values for coil outlet temperature, propene/ethene mass ratio, maximum coking rate and maximum tube metal temperature (TMT), respectively, over all the reactor coils. It is shown that feedstock flow distribution creates a larger operating window and extends the run length. Out of the four cases, the coking rate as criterion leads to the highest yearly production capacity for ethene and propene. Uniform maximum coking rates boost the annual production capacity of the USC furnace with a nameplate ethene capacity of 130 103 metric tons per year with 1000 metric tons for ethene and 730 metric tons for propene. For industrial application, achieving uniform maximum TMT is more practical due to its measurability by advanced laser‐based techniques. Most steam cracking furnaces can be retrofitted by optimizing the dimensions of venturi nozzles that regulate the feedstock flow to the coils. © 2017 American Institute of Chemical Engineers AIChE J, 63: 3199–3213, 2017

Cfd Simulation Of Cracking Tube With Internal Twisted Slices

CFD Simulation of Propane Cracking Tube Using Detailed Radical Kinetic Mechanism

Computational fluid dynamics assisted design of cracking coils

Steady and transient simulation of radiation section in a tube cracking furnace

Turbulent Mixing Enhancement of Thermal Cracking Coil by Hollow Cross Disk Internal

Fluid Dynamic Numerical Simulation Coupled With Heat Transfer And Reaction In The Tubular Reactor Of Industrial Cracking Furnaces

Numerical simulation on flow, combustion and heat transfer of ethylene cracking furnaces

SIMULATION OF THE STEAM-AIR COMBINED COKE CLEANING PROCESS FOR THE ETHYLENE CRACKING COILS

CFD Modeling of Phase Change and Coke Formation in Petroleum Refining Heaters

Numerical Simulation Of Multiple Cracking In Ansi 304 Stainless Steel Under Thermal Fatigue

Influence of key geometry parameters on heat transfer and flow resistance properties of toothed internal spiral piece cracking furnace tube

Numerical analysis of flowing cracked hydrocarbon fuel inside cooling channels in view of thermal management

Computer Simulation for Tube Crushing

Comprehensive Cfd Simulation of Product Yields and Coking Rates for A Floor- and Wall-Fired Naphtha Cracking Furnace

Computational Fluid Dynamics‐based Steam Cracking Furnace Optimization Using Feedstock Flow Distribution

CFD simulation of combustion and heat transfer in ethylene cracking furnace

Zone Method Based Coupled Simulation of Industrial Steam Cracking Furnaces

A fast simulation algorithm for industrial cracking furnaces

An Analytical Study on Cracking Directions and Damage in Thermal Fatigue Crazing Subjected to Variable Amplitude Loadings

Simulation Study on Coil of Biomass Carbonization Kettle

Thermal cracking: clarifying the effects of phases, voids and grains through characterisation and crystal plasticity modelling