Abstract:High temperature corrosion has become one of the leading causes of boiler waterwall tube failures because of the wide application of air-staged combustion in coal-fired boilers. High temperature corrosion is strongly affected by the H 2 S concentration and wall tube temperature distributions in the furnace. Particularly, the corrosion rate increases exponentially with the increase of tube temperature. However, by far most of the numerical studies on high temperature corrosion only considered the effects of H 2 S concentration while the critical effects of tube temperature were overlooked. Thus, this paper presents a comprehensive corrosion model that incorporates the key effects of both tube temperature and H 2 S concentration. Specifically, the tube temperature is predicted by a coupled combustion and hydrodynamic model that integrates the critical effects of both the boiler gas flow and steam flow on waterwall tube temperature. The H 2 S concentration is predicted by a sulfur evolution model describing the devolatilization process of coal sulfur species and their subsequent gaseous reactions. The tube temperature prediction model and H 2 S evolution model provide all the key parameters for accurate prediction of boiler waterwall corrosion. The corrosion model is applied to a 350 MW supercritical wall-fired boiler. The results show that the tube temperature varies significantly over the boiler waterwall, and hence, has significant impacts on the distribution of wall tube corrosion. Particularly, local high tube temperature zones could form on the waterwall areas of relatively low H 2 S concentration leading to substantially higher tube corrosion rates than the adjacent wall areas. The results demonstrate the importance of incorporating both the wall tube temperature and H 2 S concentration in the prediction of boiler waterwall corrosion.

Simulation Analysis of Fracture Process of Slag Deposits Surrounding Wall Tubes During Steam Sootblowing

Experimental Investigation of the Scaling-Off Location and the Slag Mass in Pulverized Coal-Fired Boiler with Water-Cooled Slag Removal

Dynamic Characteristics of Deposit Fracture and Impacts of Operating Pressure During Sootblowing in the Radiant Syngas Cooler

Numerical simulation of solidification of boiler molten ash impinging on vertical wall based on Smoothed Particle Hydrodynamics method

Numerical Simulation of the Interaction Between Supersonic Oxygen Jets and Molten Slag–Metal Bath in Steelmaking BOF Process

Simulating growth of ash deposit in boiler heat exchanger tube based on CFD dynamic mesh technique

THERMAL STRESS OF SLAG ON WALL TUBE CREATED BY BOILER LOAD SHIFT

Numerical study of solid particle erosion on sidewall

An Effective Strategy for Monitoring Slagging Location and Severity on the Waterwall Surface in Operation Coal-Fired Boilers

Simulation of Ash Deposit in A Pulverized Coal-Fired Boiler

Understanding the effects of mesh smoothing methods in the CFD modelling of Zhundong lignite ash deposition

Numerical Simulation of the Slag Splashing Process in A 120 Ton Top-Blown Converter

Numerical Simulation of Combustion Process for a Slag Tapping Boiler

Research Progress of Numerical Simulation of Slagging in Pulverized Coal Boiler

Author Response for "experimental and Numerical Modal Analysis of Wall Tubes in the Coal‐fired Boiler or Radiant Syngas Cooler"

Numerical investigation of boiler waterwall corrosion by integrated tube temperature prediction and sulfur evolution model

Modeling Freeze‐Lining Formation: A Case Study in the Slag Fuming Process

Investigation on slagging and high-temperature corrosion prevention and control of a 1000 MW ultra supercritical double tangentially fired boiler

Slagging behavior modeling in coal gasifiers using two-way coupled slag model with CFD

Improvement of slagging monitoring and soot-blowing of waterwall in a 650MWe coal-fired utility boiler

Soot﹣blowing optimization of boiler heating surface based on thermal performance mechanistic model and fuzzy comprehensive evaluation