Abstract:Aiming at the high temperature corrosion problem of the water wall of a 350 MW low nitrogen boiler in a power plant, the simulation study was carried out to adjust the air distribution and increasing near-wall air. The relationship between the concentration of reducing gases CO, H 2 S and NO x in the furnace was simulated when the burn-out air rate was 38%, 33% and 27% respectively, and the effect of increasing the wall air on the concentration of reducing gases near the water wall was simulated. The results show that the burn-out air rate is reduced from 38% to 33%, which can reduce the concentration of reducing gases CO and H 2 S in the furnace by 20% without significantly increasing the amount of NO x , and slow down the high-temperature corrosion of the water wall. Reducing the burn-out air rate from 38% to 27% can increase the oxygen concentration in the main combustion zone, reduce the production of CO and H 2 S, and slow down the high-temperature corrosion of the water wall, but the NO x concentration will increase significantly. The high-temperature corrosion area in the furnace is mainly located between the UAP nozzle of the compact burnout air and the SOFA3 nozzle of the intermediate burnout air. The near-wall air can be added on both sides of the UAP nozzle of the compact burnout air. The simulation results show that the concentration of CO and H 2 S near the water wall can be reduced by increasing the near-wall wind with the same rotation direction as the main flow, and there is the small effect on the flow field. Due to the high concentration of CO near the water wall, the flow of near-wall air on both sides is larger, which has better effect on reducing CO near the water wall. The coverage area of near-wall air on both sides is larger for high-temperature corrosion area, while the concentration of H 2 S near the water wall is lower. There is no obvious difference between the single-side near-wall air and the double-side near-wall air in reducing the H 2 S of the water wall, but the double-side near-wall air will disturb the distribution of the flow field, which is not conducive to pulverized coal combustion.

Numerical investigation of boiler waterwall corrosion by integrated tube temperature prediction and sulfur evolution model

A coupled combustion and hydrodynamic model for the prediction of waterwall tube overheating of supercritical boiler

Water Wall Tubes’ High Temperature Corrosion Root Cause Investigation: A 300 MW Level Boiler Case

Research & Development of Boiler Tube Wall Temperature Calculation System

Analysis and Solution of High-temperature Corrosion for a 1000 MW Ultra-supercritical Boiler

Application of Multi-Tangential Firing Technology to Settling the High Temperature Corrosion of Water Wall Tube of Boiler

Integrating Flow Field Dynamics and Chemical Atmosphere Predictions for Enhanced Sulfur Corrosion Risk Assessment in Power Boilers

Steam Temperature Characteristics in Boiler Water Wall Tubes Based on Furnace CFD and Hydrodynamic Coupling Model

Investigation on slagging and high-temperature corrosion prevention and control of a 1000 MW ultra supercritical double tangentially fired boiler

Prediction of tube temperature distribution of boiler platen superheater by a coupled combustion and hydrodynamic model

Effect of burnout air rate and wall air on high temperature corrosion of water wall of 350 MW tangentially fired boiler

High-temperature corrosion of water-wall tubes in oxy-combustion atmosphere

Experimental and Modeling Study of H2S Formation and Evolution in Air Staged Combustion of Pulverized Coal

Computational Analysis of Tube Wall Temperature of Superheater in 1000 MW Ultra-Supercritical Boiler Based on the Inlet Thermal Deviation

A Study of Thermal Analysis Kinetics for High Temperature Corrosion of Water Wall Tube 20g at Different Density SO2

Numerical Study and Structural Optimization of Water-Wall Temperature-Measurement Device for Ultra-Supercritical Boiler

Experimental and Modeling Studies on Sulfur Trioxide of Flue Gas in a Coal-Fired Boiler

Corrosive damage analysis and characterization of boiler tubes in a secondary superheater

Experimental test, numerical analysis and thermal calculation modeling of hundreds kW th -class supercritical CO 2 fossil-fired boiler system

Development of Sulfur Release and Reaction Model for Computational Fluid Dynamics Modeling in Sub-Bituminous Coal Combustion

Effect of Circumferential Flow Non-uniformity on the Temperature Distribution of Membrane Water Wall in Supercritical Boilers and Simplified Calculation Methods