Abstract:Aiming at the high temperature corrosion problem of the water wall of a 350 MW low nitrogen boiler in a power plant, the simulation study was carried out to adjust the air distribution and increasing near-wall air. The relationship between the concentration of reducing gases CO, H 2 S and NO x in the furnace was simulated when the burn-out air rate was 38%, 33% and 27% respectively, and the effect of increasing the wall air on the concentration of reducing gases near the water wall was simulated. The results show that the burn-out air rate is reduced from 38% to 33%, which can reduce the concentration of reducing gases CO and H 2 S in the furnace by 20% without significantly increasing the amount of NO x , and slow down the high-temperature corrosion of the water wall. Reducing the burn-out air rate from 38% to 27% can increase the oxygen concentration in the main combustion zone, reduce the production of CO and H 2 S, and slow down the high-temperature corrosion of the water wall, but the NO x concentration will increase significantly. The high-temperature corrosion area in the furnace is mainly located between the UAP nozzle of the compact burnout air and the SOFA3 nozzle of the intermediate burnout air. The near-wall air can be added on both sides of the UAP nozzle of the compact burnout air. The simulation results show that the concentration of CO and H 2 S near the water wall can be reduced by increasing the near-wall wind with the same rotation direction as the main flow, and there is the small effect on the flow field. Due to the high concentration of CO near the water wall, the flow of near-wall air on both sides is larger, which has better effect on reducing CO near the water wall. The coverage area of near-wall air on both sides is larger for high-temperature corrosion area, while the concentration of H 2 S near the water wall is lower. There is no obvious difference between the single-side near-wall air and the double-side near-wall air in reducing the H 2 S of the water wall, but the double-side near-wall air will disturb the distribution of the flow field, which is not conducive to pulverized coal combustion.

Application of Multi-Tangential Firing Technology to Settling the High Temperature Corrosion of Water Wall Tube of Boiler

Research & Development of Boiler Tube Wall Temperature Calculation System

Research on Protective Measures to High-Temperature Corrosion of a Novel Energy-Saving Phosphorus Reaction Tower

Study on coal combustion characteristics in a 350MW supercritical tangentially boiler

Analysis and Solution of High-temperature Corrosion for a 1000 MW Ultra-supercritical Boiler

Investigation on slagging and high-temperature corrosion prevention and control of a 1000 MW ultra supercritical double tangentially fired boiler

Numerical investigation of boiler waterwall corrosion by integrated tube temperature prediction and sulfur evolution model

Application study on enamel heat exchange tube in GGH of coal-fired units with ultra-low flue gas emission

Effect of burnout air rate and wall air on high temperature corrosion of water wall of 350 MW tangentially fired boiler

Research Progress in the Corrosion Mechanisms and Anticorrosion Technologies of Waste-to-Energy Plant Boilers

Water Wall Tubes’ High Temperature Corrosion Root Cause Investigation: A 300 MW Level Boiler Case

A Study of Thermal Analysis Kinetics for High Temperature Corrosion of Water Wall Tube 20g at Different Density SO2

Analysing the Cause of High Temperature Corrosion in the Superheaters of Power Plant Systems

Heat Flux Distribution on Circulating Fluidized Bed Boiler Water Wall

Application of FAHP in Quantitative Analysis on Factors Influencing High Temperature Corrosion in Utility Boilers

Experimental study on high temperature gaseous hydrogen fluoride corrosion of boiler water-cooled wall pipes

Performance Analysis of the Technology of High-Temperature Boiler Feed Water to Recover the Waste Heat of Mid–Low-Temperature Flue Gas

Numerical Study and Structural Optimization of Water-Wall Temperature-Measurement Device for Ultra-Supercritical Boiler

DYNAMICS STUDY ON CORROSION TEST IN GAS-PHASE HC1 FOR SUPERHEATERS OF BIOMASS BOILERS

Experiment and Investigation of Overheating Problem of 300MW Boiler's HT Reheater

High-temperature corrosion of water-wall tubes in oxy-combustion atmosphere