Abstract:High temperature corrosion poses a great threat to boiler water wall safe operation. To investigate the corrosion root cause, a 300 MW level boiler water wall high temperature H2S corrosion case was reported. The typical hydrogen sulfide H2S corrosion feature was large amounts of sulfur which could be found in the cut down sample tube corrosion layer, with a thickness of 482 μm. In addition, huge amounts of lead (Pb) could be found in the corrosion layer, which resulted from the lead sulfide (PbS) deposition when the high temperature flue gas condensed at the water wall tubes. Meanwhile, the sulfur in the corrosion layer was closely related to the H2S concentration in the water wall ambience. The related ambience test showed that the H2S could achieve up to 1000 ppm when the boiler was in operation, far larger than the suggested reference value of 100 ppm. Hence, the overlarge H2S concentration was a vital factor for the tube corrosion. To further investigate the reason why the H2S was kept in such high concentration in the boiler long term operation, and the reasons for the over-high sulfur content in the coal and the over-large diameter of the imaginary circle of primary air (DICPA), two factors were obtained. The peak sulfur content reached 2.5% and the suggested sulfur content was below 1%. The DICPA was so large (1580 mm) that the pulverized coal easily scoured the water wall tubes, which would boost the thinning process of the tubes. To relieve the high temperature corrosion, improve the coal qualities, decrease the DICPA, adjust the operation diameter and adopt a coating technology four measures were suggested.

Analysing the Cause of High Temperature Corrosion in the Superheaters of Power Plant Systems

Cause Analyses of the Weld Seam Cracks of a Prehydrogenating Reactor

Analysis of Superheater’s Pipe Wall Overtemperature by Fault Tree Diagnose

Study on coal combustion characteristics in a 350MW supercritical tangentially boiler

Analysis and Solution of High-temperature Corrosion for a 1000 MW Ultra-supercritical Boiler

Application of Multi-Tangential Firing Technology to Settling the High Temperature Corrosion of Water Wall Tube of Boiler

A Typical Super-Heater Tube Leakage and High Temperature Corrosion Mechanism Investigation in a 260 T/h Circulated Fluidized Boiler

Investigation on High-temperature Corrosion of Superheaters in Biomass Boiler

Investigation on High Temperature Corrosion of Water-Cooled Wall Tubes at a 300 MW Boiler

Experimental Study on High Temperature Corrosion of Five Superheater Materials for Power Plant Boilers

High-Temperature Corrosion Properties of Boiler Steels under A Simulated High-Chlorine Coal-Firing Atmosphere

Field Study on the Corrosion and Ash Deposition of Low-Temperature Heating Surface in a Large-Scale Coal-Fired Power Plant

Evaluation and Improvement of the Coupled Effect of High-temperature Corrosion-erosion on Water Wall Tubes

An Analysis of the Cause of a Superheater Tube Explosion Occurring in a 40 t/h Gas-fired Boiler

Investigation on slagging and high-temperature corrosion prevention and control of a 1000 MW ultra supercritical double tangentially fired boiler

High-temperature corrosion data and mechanisms for T122, Super304H and HR3C after 15 years in 1000MW ultra-supercritical power plant

DYNAMICS STUDY ON CORROSION TEST IN GAS-PHASE HC1 FOR SUPERHEATERS OF BIOMASS BOILERS

Characteristic Analysis of Superheater Tubes of Biomass Direct-fired Boilers

Corrosive damage analysis and characterization of boiler tubes in a secondary superheater

Water Wall Tubes’ High Temperature Corrosion Root Cause Investigation: A 300 MW Level Boiler Case

CORROSION CHARACTERS OF TP347H STEEL UNDER ATMOSPHERE OF SUPERHEATERS OF BIOMASSBURNED BOILERS(II)