Abstract:In the current study, a 3-D microscopic structural finite element (FE) model of interpenetrating SiC/Al composites (SiC/Al IPCs) is built, based on X-ray tomography and optimized methods for 3-D mesh generation. In addition, an interface model is introduced into the 3-D FE model to investigate the effects of the interfaces on the damage and failure processes, which includes a “tie-break contact” method at the SiC/Al interfaces. Subsequently, FE methods are applied to investigate the dynamic compression response of the 3-D FE model. To validate the numerical simulation results, the dynamic compression responses of SiC/Al IPCs are measured at strain rates of 2000s−1 using a split Hopkinson pressure bar device. Our results show that failure of the SiC phase occurs just before the effective stress reaches its peak, but it plays a leading role in bearing the pre-metaphase stage of the load. From the point of energy dissipation, however, the contribution of Al phase cannot be ignored in the final stage of failure because the residual Al phase absorbs 30% of the energy of the global model by plastic deformation, even though its mass failure ratio is only 2%. Further microanalysis shows that the cracks initiate and propagate mainly near the SiC/Al interface, just on the side of the SiC ceramic phase. As the cracks extend further into the SiC phase, there appears a new “interface debonding” failure mode. These results show that brittle fracture of the SiC ceramic phase plays a key role in crack initiation, since the presence of complex 3-D SiC/Al interfaces usually causes the generated cracks to deflect before interconnecting with each other. This significantly retards propagation of the cracks, and thus increases the ductility of the composite materials. In the final stage of failure, the cracks are interconnected with each other in the SiC phase while the Al phase still maintains a degree of structural integrity. It is found that there exists obvious plastic deformation in local, relatively narrow, regions in the Al phase, and the local necking and tearing fractures tend to be localized in these severely deformed regions. Numerical simulation results are consistent with the observed behavior.

Discrete Element Simulation of Transverse Cracking During the Pyrolysis of Carbon Fibre Reinforced Plastics to Carbon/Carbon Composites

Mechanical Behavior of SiCf/SiC Composites with Alternating PyC/SiC Multilayer Interphases

A study of transverse ply cracking using a discrete element method

Fracture Mechanism of 2D-C/C Composites with Pure Smooth Laminar Pyrocarbon Matrix under Flexural Loading

Fracture Behavior of Sic/Sic Composites with Different Interfaces

Exploring the Toughening Mechanisms of PyC Interphase in SiCf/SiC Composites Through Molecular Dynamics and Mesoscale Stochastic Simulations

Simulation of Damage and Failure Processes of Interpenetrating SiC/Al Composites Subjected to Dynamic Compressive Loading

Experimental and FEM study of thermal cycling induced microcracking in carbon/epoxy triaxial braided composites

Matrix Cracking of 2D SiC/SiC Composite Characterized by in Situ SEM and Nano-Ct

Multiscale Image-Based Modelling of Damage and Fracture in Carbon Fibre Reinforced Polymer Composites

3D Characterizations of Pores and Damages in C/SiC Composites by Using X-Ray Computed Tomography

Finite Element Modeling of Thermal Cycling Induced Microcracking in Carbon/Epoxy Triaxial Braided Composites

Internal Damage Evolution of C/SiC Composites in Air at 1650 °C Studied by In-Situ Synchrotron X-ray Imaging

Experimental and numerical studies on low-velocity impact of laminated C/SiC structures

A Monte Carlo simulation of damage and failure process with crack saturation for unidirectional fiber reinforced ceramic composites

Investigation on crack propagation of SiCf/SiC composite via PF-CZM method

Analysis of the Damage Initiation in a SiC/SiC Composite Tube from a Direct Comparison Between Large-Scale Numerical Simulation and Synchrotron X-ray Micro-Computed Tomography

Molecular dynamics simulation on PyC interfacial failure mechanism and shear strength of SiC/SiC composites

Actively-controlled PyC Interphase Failure Mechanisms in C/SiC Composite Revealed Using Micro-Mechanical Interfacial Testing

Mechanical properties and in situ crack growth observation of SiC/SiC composites

Effects of Thermal Cycling on Damage Progress in Interlaminar-Toughened CFRP Cross-Ply Laminates