Abstract:<p class="a-plus-plus">Numerical analysis of growth of fractures from a wellbore under sleeve fracturing conditions demonstrates the impact of in situ stresses on initiation and propagation behavior of primary and secondary cracks at both field and lab scale. Crack initiation and propagation behavior are simulated in a Finite Element framework employing plane-strain cohesive element along the candidate crack paths. The model has been validated by benchmarking to Kirsch's solution as well as by comparing predictions to results of a laboratory block test. Indeed, the field scale simulation results show that the first fracture always orients with the opening in direction of maximum in situ stress while the opening direction of the second fracture can vary with different in situ stresses. Furthermore, the deviation of wellbore displacement from the Kirsch solution due to the fracture initiation can be captured by the simulation, which can be further applied to interpret the initiation pressure and location of cracks based on field test data. In the context of past contributions on sleeve fracturing, these numerical results demonstrate that a relatively large region near the crack tip undergoes inelastic deformation, which contrasts with the assumptions required to treat this problem using linear elastic fracture mechanics (LEFM). Notably, the finite tip plasticity appears to eliminate unstable jumping of the crack length(s) predicted by LEFM solution. The finite tip plasticity also leads to the prediction that the secondary fracture often occurs in orientations other than 90° to the primary fracture. In contrast, the LEFM solution predicts none of this growth because the stress intensity factor (SIF) never reaches the rock fracture toughness in spite of the fact that these alternate orientations have the largest SIFs over limited periods of time. Finally, the finite tip plasticity shows the strength of materials approach (based on stress analysis around the hole) to give a lower bound estimate of the pressure required for crack extension.</p>

Evaluation of the Stress-Strain State at the Crack Tip in Casing Pipes Based on Numerical Simulation

Effect of Structural State and Temperature on Crack Generation and Propagation Resistance in Pipe Steels

Simulation Of Delamination Of Steel Pipes Under Complex Loading

Study of Strain Capacity for High-Strain Marine Pipe

Evaluation of Mechanical Properties and Microstructures of Casing-Drilling Steels

Study on the Static and Dynamic Fracture Mechanism of Different Casing-Drilling Steel Grades

Numerical study on the strain capacity of girth-welded X80 grade pipes

Numerical Simulation of Central Shrinkage Crack Formation in a 234-T Steel Ingot

Numerical Simulation and Experimental Verification of Ductile Fracture Criteria of Metals

Study on fatigue crack growth behavior of casing-drilling steel N80

Investigation of Fracture Mechanism of Casing-Drilling Steels

Numerical Simulation of Sleeve Fracturing for In Situ Stress Measurement Using Cohesive Elements and Its Implications

COMPUTATIONAL AND EXPERIMENTAL STUDY OF THE FALLING LOAD TEST OF HIGH-STRENGTH PIPE STEEL X100 (K80)

In-situ observation of strain evolution and ratchetting of growing fatigue cracks

Computer Simulation for Tube Crushing

Experimental and Numerical Evaluation on Deformation and Fracture Mechanism of Cast Duplex Stainless Steel Tubular Specimen

Study on Stress Intensity Factor of Girth Weld with Crack Defects

Numerical Simulation Of Multiple Cracking In Ansi 304 Stainless Steel Under Thermal Fatigue

Multi-axial Creep-Fatigue Analysis of a Cracked Groove Structure Subjected to Cyclic Thermal Loading

Failure Analysis of Abnormal Bulging and Cracking for High-Pressure Steam Pipe

Crack growth behavior of low carbon steel at high temperature