Abstract:Accurate prediction of flow mode in pneumatic conveying can be beneficial for design of a reliable pneumatic conveying system. The existing popular powder classification diagrams use particle or loose poured bulk density and average particle diameter. An evaluation carried out with powder characterization and conveying data of 58 powders reveals that all the existing classification diagrams have some overlapping zones between fluidized dense- and dilute-phase. Such uncertainty significantly limits the use of existing classification diagrams. A new classification diagram has been developed using the powder characterization and conveying data of 58 powders for fluidized dense to dilute-phase regime using a modified particle Froude number term (based on loose poured bulk density) and particle size distribution. The novelty of this classification diagram is that it uses coarse to fine ratio (instead of average particle size) and a loose poured bulk density based Froude number term which uses both loose poured bulk density and median size. Hence, the classification diagram considers larger number of particle and bulk properties: loose poured bulk density and different particle size terms (such as d10, d50, d90, instead of only d50). The new characterization diagram quantitatively marks an uncertain zone in the classification diagram, which in the zone the powders can be transported in either dense-phase or dilute-phase, as there is no certainty on the expected nature of flow for powders falling in these zones and hence these powders must be tested in a pilot plant for conveyability.

Development of a New Centrifugal Pneumatic Classifier for Powder Materials

Classifier performance of NHF-II air centrifugal rotor superfine power classifier

Development of Centrifuge for Multi-Parameter Combined Environmental Test

Experimental Study on Pneumatic Classification of Fine-Metal-Powder

Principle and Application of the GFX Centrifugal Classifiers

Electrostatic Classification of Fine Powders

Research Progress of Electrostatic Measurement Technique for Dynamic Powders

Numerical Simulation of a Flow Field in a Turbo Air Classifier and Optimization of the Process Parameters

Developing pneumatic conveying classification diagram for powders

Numerical Simulation Analysis of Ultrafine Powder Centrifugal Classifier

Application of Near-Infrared Spectroscopy Combined with Design of Experiments for Process Development of the Pulsed Spray Fluid Bed Granulation Process

Enhancement of the classification and recovery process of fine mineral particles via a newly developed volute feed hydrocyclone

Fine particle sorting and classification in the cyclonic centrifugal field

Influence of guide vane on dispersion of aggregates near the guide vane in a turbo air classifier

Design of Parallel Pipeline System with Multi - Point Extraction for Fly Ash Classification

Narrowing particle size distributions to enhance powder coating performance by improved classifying

Advances in Technology for Manufacture of Large Granular Urea

Design and Research on the Type NHJW- Ⅰ Ultrafine Classifier

CFD simulation and performance optimization of a new horizontal turbo air classifier

The Application of a New Type of Hydraulic Classification Equipment: Swirl Continuous Centrifugal Separator

Vortex analysis and flow field optimization for the particle classifier with three rotary cages