Abstract:Accumulation of electrostatic charges in gas–solid fluidized beds can lead to particle adhesions, electrostatic discharges, wall sheeting and even explosion. Therefore, it is of vital importance to reduce the electrostatic level in industrial fluidized beds. Adding chemical static agents was reported as one of the most promising ways to control fluidized bed electrostatic potentials. In this study, the electrostatic potential distributions were measured in a three-dimensional column gas–solid fluidized bed with the LLDPE particles for fluidization and the introduction of chemical static agents. Seven charge inducing agents including TiO2, Al2O3, MgO, H2O, C2H5OH, ZnO, and Fe2O3 were employed to investigate their influence on electrostatic potentials distribution respectively. Additionally, Al(Et)3, which is normally used as the cocatalyst for olefin polymerization, was also studied for comparison. It was found that the adding of negative charge inducing agent such as TiO2 made the positive electrostatic potentials shift to higher values and the negative electrostatic potentials shift to lower values. The injection of positive charge inducing agent such as Al2O3 and MgO caused the positive electrostatic potentials dropping to lower values and the negative electrostatic potentials shifting to the values near zero at low injection amount. Affecting mechanism of charge inducing agents was discussed based on the experimental results and the electronegativity of corresponding compounds. It was found that the electronegativity (χi) of the metal ion played an important role in determining the charge polarity on the LLDPE particles and the change in the electrostatic potentials after contact and separation with the charge inducing agent particles.

Electrostatic Classification of Fine Powders

Electrostatic Precipitation of Fine Particles with a Bipolar Pre-Charger

Experimental Investigation of Electrostatic Reduction in a Gas–Solid Fluidized Bed by an in Situ Corona Charge Eliminator

Cfd-Dem Investigation of Particle Elutriation with Electrostatic Effects in Gas-Solid Fluidized Beds

Monitoring of Particle Motions in Gas-Solid Fluidized Beds by Electrostatic Sensors

Electrostatic Potentials in Gas–solid Fluidized Beds Influenced by the Injection of Charge Inducing Agents

Electrostatic potential in gas-solids fluidized beds influenced by injection of charge inducing agents

Electroless Co-P Alloy Plating of Superfine Si3N4 Powders

Studies of synthesizing the SiC nanometer powders by chemical vapor reaction

Bipolar Charging of Dielectric Powder and Electrostatic Potential Distribution in Gas-Solid Fluidized Beds

Electrostatic behavior with fines of different sizes added into gas-solid fluidized bed

Investigation on the Packing of Fine Particles in Presence of High-Voltage Electric Field

Narrowing particle size distributions to enhance powder coating performance by improved classifying

Experiments on enhancing the particle charging performance in an 1 electrostatic precipitator 2

Numerical analysis of frictional charging and electrostatic interaction of particles

Effect of particles' electric charge on the separation process using an electro-adhesion actuator

Preparation of fine copper powders by galvanostatic regime of electrolysis of copper scrap in a cylindrical electrochemical cell

Ultra-Fine Treatment of Sic Powder and Its Effect on Microstructure and Properties of Sic Ceramic

Preparation and Application of Ultrafine Copper Powder

Direct Determination of Impurities in High Purity Silicon Carbide by Inductively Coupled Plasma Optical Emission Spectrometry Using Slurry Nebulization Technique

Experiments on Enhancing the Particle Charging Performance of an Electrostatic Precipitator