Abstract:Accumulation of electrostatic charges in gas–solid fluidized beds can lead to particle adhesions, electrostatic discharges, wall sheeting and even explosion. Therefore, it is of vital importance to reduce the electrostatic level in industrial fluidized beds. Adding chemical static agents was reported as one of the most promising ways to control fluidized bed electrostatic potentials. In this study, the electrostatic potential distributions were measured in a three-dimensional column gas–solid fluidized bed with the LLDPE particles for fluidization and the introduction of chemical static agents. Seven charge inducing agents including TiO2, Al2O3, MgO, H2O, C2H5OH, ZnO, and Fe2O3 were employed to investigate their influence on electrostatic potentials distribution respectively. Additionally, Al(Et)3, which is normally used as the cocatalyst for olefin polymerization, was also studied for comparison. It was found that the adding of negative charge inducing agent such as TiO2 made the positive electrostatic potentials shift to higher values and the negative electrostatic potentials shift to lower values. The injection of positive charge inducing agent such as Al2O3 and MgO caused the positive electrostatic potentials dropping to lower values and the negative electrostatic potentials shifting to the values near zero at low injection amount. Affecting mechanism of charge inducing agents was discussed based on the experimental results and the electronegativity of corresponding compounds. It was found that the electronegativity (χi) of the metal ion played an important role in determining the charge polarity on the LLDPE particles and the change in the electrostatic potentials after contact and separation with the charge inducing agent particles.

Research Progress of Electrostatic Measurement Technique for Dynamic Powders

Monitoring of Particle Motions in Gas-Solid Fluidized Beds by Electrostatic Sensors

A Comparative Study of Electrostatic Current and Pressure Signals in a MSFC Gas–solid Fluidized Bed

Experimental Investigation of Electrostatic Effect on Particle Motions in Gas-Solid Fluidized Beds

Experimental Investigation of Electrostatic Reduction in a Gas–Solid Fluidized Bed by an in Situ Corona Charge Eliminator

Electrostatic Classification of Fine Powders

Online Measurement of Particle Charge Density in A Gas-Solid Bubbling Fluidized Bed Through Electrostatic and Pressure Sensing

Recent Progress of Dry Electrostatic Precipitation for PM 2 . 5 Emission Control from Coal-fired Boilers

Electrostatic Potentials in Gas–solid Fluidized Beds Influenced by the Injection of Charge Inducing Agents

Cfd-Dem Investigation of Particle Elutriation with Electrostatic Effects in Gas-Solid Fluidized Beds

Characterization of Electrohydrodynamic Flow in a Plate-Plate Electrostatic Precipitator with a Wire-Cylinder Pre-Charger by Data-Driven Vortex and Residence Time Analysis

Numerical simulation of gas-solids fluidized bed with applied electric field

Experimental Investigation of Electrostatic Effect on Bubble Behaviors in Gas-Solid Fluidized Bed

Electrostatic discharge mechanisms and dynamic characteristics of different polarity powders in the Silo

Review on CFD modeling of electrostatic powder charging during pneumatic conveying

Research Progress of Electrostatic Spray Technology over the Last Two Decades

Electrostatic sensors – Their principles and applications

Unmasking hidden ignition sources: A new approach to finding extreme charge peaks in powder processing

Investigation on the Packing of Fine Particles in Presence of High-Voltage Electric Field

Numerical analysis of frictional charging and electrostatic interaction of particles

Spatially resolved measurement of the electrostatic charge of turbulent powder flows