Abstract:The classification performance of model coal mill classifiers with different bottom incoming flow inlets was experimentally and numerically studied. The flow field adjacent to two neighboring impeller blades was measured using the particle image velocimetry technique. The results showed that the flow field adjacent to two neighboring blades with the swirling inlet was significantly different from that with the non-swirling inlet. With the swirling inlet, there was a vortex located between two neighboring blades, while with the non-swirling inlet, the vortex was attached to the blade tip. The vorticity of the vortex with the non-swirling inlet was much lower than that with the swirling inlet. The classifier with the non-swirling inlet demonstrated a larger cut size than that with the swirling inlet when the impeller was stationary (similar to 0 r.min(-1)). As the impeller rotational speed increased, the cut size of the cases with non-swirling and swirling inlets both decreased, and the one with the non-swirling inlet decreased more dramatically. The values of the cut size of the two classifiers were close to each other at a high impeller rotational speed (>= 120 r.min(-1)). The overall separation efficiency of the classifier with the non-swirling inlet was lower than that with the swirling inlet, and monotonically increased as the impeller rotational speed increased. With the swirling inlet, the overall separation efficiency first increased with the impeller rotational speed and then decreased when the rotational speed was above 120 r.min(-1), and the variation trend of the separation efficiency was more moderate. As the initial particle concentration increased, the cut sizes of both swirling and non-swirling inlet cases decreased first and then barely changed. At a low initial particle concentration (<0.04 kg.m(-3)), the classifier with the swirling inlet had a larger cut size than that with the non-swirling inlet. (C) 2019 The Chemical Industry and Engineering Society of China, and Chemical Industry Press Co., Ltd. All rights reserved.

The Application of a New Type of Hydraulic Classification Equipment: Swirl Continuous Centrifugal Separator

Study on Separation Mechanism of Falcon Concentrator and Its Application

Enhancement of the classification and recovery process of fine mineral particles via a newly developed volute feed hydrocyclone

Studies of a Water-Only Cyclone with a Three-Stage Cone for Fine Coal Beneficiation

Experimental Study on Performance of a Continuous Centrifugal Concentrator in Reconcentrating Fine Hematite

Industrial Test on Recovering Microfine Iron Minerals by Slon Continuous Centrifugal Separator

Application of SLon Continuous Centrifugal Separators in Recovering Fine Iron Minerals from Mine Tailings

Recovery of iron from fine iron tailings by continuous centrifugal concentration

Principle and Application of the GFX Centrifugal Classifiers

Preconcentrating Ultrafine Ilmenite Tailings Using a Laboratory-Scale Reflux Classifier

Investigation of an external loop airlift slurry separator for precise grading of solid particles

Experimental and theoretical study on strengthening mechanism of coarse coal slime classification process with cone wall structure

Development and performance of a permanent magnet pulsating separator

Test Research on Reconcentration of Hainan Steel's Tailings by High Intensity Magnetic Separation-Centrifugal Separator

Experimental investigation on separation characteristics of axial cyclone separator

Numerical Simulation and Experimental Validation for Investigating the Novel Hydraulicbarrier-Hydrocyclone in Industrial Beneficiation Process

Study of honeycomb cone combined hydrocyclone for separating blast furnace gas sludge

Cyclonic Separation Technology: Researches and Developments

A short review on hydraulic classification and its development in mineral industry

Classification Performance of Model Coal Mill Classifiers with Swirling and Non-Swirling Inlets

Numerical Investigation of the Effect of Slurry Viscosity on Centrifugal Classification of Pseudo-Boehmite in Continuous-Carbonation Preparation Process