Abstract:Dense medium cyclones (DMCs) are widely used in coal mine sorting processes to improve the quality of coal products and reduce pollution. The conventional linear inlet DMCs has the problems of unstable flow field, high turbulence density and low separation efficiency. Based on these concerns, the volute inlet DMCs was proposed, however the nose angle as one of the most critical parameters has not yet been investigated in depth. In this paper, a DMC with volute inlet is investigated, and the effect of nose angle is studied by a computational fluid dynamics model in terms of flow field, particle motion and the forces acting on the particles. The performance of the DMC is evaluated with respect to the inlet nose angle. As the nose angle increases from 0 to 180 deg., the separation efficiency has a tendency to increase and then decrease with the inflection point founding when nose angle is 180 deg. Then the flow field, particle distribution and particle force are analyzed respectively. The results show that the symmetry and stability of the flow field can be significantly improved as nose angle increases from 0 to 180 deg., but they remain almost constant when nose angle is 270°. In addition, a quantification method of the short-circuiting flow is established and it has been found that increasing the nose angle can notably reduce the short-circuiting flow. In terms of particle phase, increasing the nose angle causes heavier particle distribution tends to concentrate. During this period, the variation pattern of forces on particles with different nose angles is also analyzed. The DMC with a nose angle of 180 deg. has a longer acceleration zone at the entrance height and an increased radial force on the particles, which results in better performance. This study provides a theoretical basis and reference for the structure optimization of dense medium cyclones.

Influence of guide vane on dispersion of aggregates near the guide vane in a turbo air classifier

The influence of air inlet layout on the inner flow field for a vertical turbo air classifier

Effects of a Guide Cone on the Flow Field and Performance of a New Dynamic Air Classifier

Vortex analysis and flow field optimization for the particle classifier with three rotary cages

Performance Evaluation of a New Micro Gas Cyclone Using Simulation and Experimental Studies to Capture Indoor Fine Particles

Experimental Study on Velocity Field Between Two Adjacent Blades and Gas–solid Separation of a Turbo Air Classifier

Numerical Simulation Analysis of Ultrafine Powder Centrifugal Classifier

CFD simulation and performance optimization of a new horizontal turbo air classifier

Measurement of the D*+/- cross section in two-photon processes.

Numerical Simulation of a Flow Field in a Turbo Air Classifier and Optimization of the Process Parameters

Influence of Cyclone Combustor Structure on the Motion Behaviors of Solid Fuel Particles

Performance improvement of a cyclone separator using spiral guide vanes with variable pitch length

Multi-objective optimization of a novel vortex finder for performance improvement of cyclone separator

Promotion of particle agglomeration by different vortex generator angles based on PIV-PDPA experiment

Numerical simulation of the particle-wall collision strength and swirling effect on the performance of the axial flow cyclone separator

The Influence of the Design of a Static Multi-Vortex Classifier on the Efficiency Fractionation of Silica Gel Particles

CFD-DEM Investigation of the Fluidization of Binary Mixtures Containing Rod-Like Particles and Spherical Particles in a Fluidized Bed

Investigation of the Vibrating Feeding System for Sphericity Separation of Coated Fuel Particles Using DEM

Influences of Various Vortex Structures on the Dispersion and Deposition of Small Ash Particles

Influence of nose angle on performance of dense medium cyclones with volute inlet

Numerical Study on Flow Behavior of Ultrafine Powders in Conical Spouted Bed with Coarse Particles