Abstract:The transition section between bottom dense zone and top dilute zone is important for fast gas-solids catalytic reactions,such as methanol to olefins(MTO).Solids concentration and fluctuation parameters in the transition section of a fluidized bed with 95 mm i.d.were measured by using reflective optical fiber probe(PV6D).The influences of superficial gas velocity and static bed height were investigated.An Eulerian-Eulerian two-fluid model that incorporated kinetic theory of granular flow and modified three-zone drag law was used to predict the flow structure in the turbulent fluidized bed.The axial and radial distributions of solids concentration were simulated by means of computational fluid dynamics(CFD).The experiments showed two axial profiles of solids distribution in the transition section:exponential and S-shaped.The maximum gradients of both axial and radial solids concentration profiles were located in the transition section,which meant that solids distribution in the transition section was much more non-uniform than that in the dilute and dense sections.The change of gas velocity and static bed height would cause a shift between exponential and S-shaped profiles,and significantly affect solids concentration in the dense region near the wall and at the bottom.Probability density distribution of local solids concentration revealed that when static bed height was small,the location of maximum voidage would gradually move from core region to annular region with increasing gas velocity,resulting in a bimodal distribution of voidage.A modified three-zone drag model was proposed by taking the effect of particle clustering into account for CFD simulation.The simulated solids concentration distribution agreed well with experimental data in the transition section except for the distributor zone.

Influences of Various Vortex Structures on the Dispersion and Deposition of Small Ash Particles

Influences of vortices on impaction and distribution of small ash particles on rear side surface of boiler tube

Experimental and Numerical Study of Solids Concentration Distribution in Transition Section of Turbulent Fluidized Bed

Modelling of heavy and buoyant particle dispersion in a two-dimensional turbulent mixing layer

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

Dispersion Trajectory and Dynamics of Particles Injected from the Sidewall in the Gas–Solid Fluidized Bed

DEM–CFD Simulation of the Particle Dispersion in a Gas–solid Two-Phase Flow for a Fuel-Rich/lean Burner

DIRECT NUMERICAL SIMULATION OF VORTEX STRUCTURES AND PARTICLE DISPERSION IN TURBULENT FREE SHEAR FLOWS

Dynamic CFD modeling evaluation of ash deposition behavior and morphology evolution with different tube arrangements

Influence of Cyclone Combustor Structure on the Motion Behaviors of Solid Fuel Particles

Dynamic evaluation of ash deposition behavior and parametric study using an inverse distance weighted interpolation dynamic mesh method

Effects of Coherent Structures on Nanoparticle Coagulation and Dispersion in a Round Jet

Numerical Simulation of Effects of Venturi Tube Throat Diameter on Flow Field of Combustor

NUMERICAL SIMULATION OF ULTRAFINE PARTICLE-LADEN CYLINDER WAKE FLOW WITH COHERENT STRUCTURES

Numerical Investigation of Fly Ash Deposition onto Tube Bundles Inside Coal-Fired Boilers

Understanding the Ash Deposition Formation in Zhundong Lignite Combustion Through Dynamic CFD Modelling Analysis

A Numerical Study of Ash Deposition Characteristics in a 660MW Supercritical Tangential Boiler

A Numerical Simulation Study into the Effect of Longitudinal and Transverse Pitch on Deposition of Zhundong Coal Ash on Tube Bundles

Numerical Simulation of the Effects of Center Tube and Multiple Air Injection on the Gas Flow Field in a Vortex Combustor

Graphite Dust Deposition on HTGR Steam Generator: Effects of Particle-Wall and Particle-Vortex Interactions

Simulation of the Lateral Movement on Particles Under Continuous Feeding and Discharging in a CFB Dense Zone