Abstract:Deposition on heat exchange surfaces is an urgent problem to be solved to achieve efficient utilization of energy in thermal equipment. To mitigate deposition and the resultant heat attenuation, this work proposes a mixed tube bundle strategy of inserting attached cylinders behind the tube bundle, which can effectively meet the design requirements of high anti-deposition performance, high heat transfer efficiency, and low flow resistance. An integrated dynamic model for deposition is developed to elucidate the effect of ash particles on deposition, flow, and heat transfer characteristics. Based on the inverse distance weighting interpolation, a dynamic mesh smoothing technique is employed to simulate the evolving deposition layer on the heat transfer surface. In addition, the L 16 (4 3 ) orthogonal experimental design method is adopted to study the influence of the arrangement angle, diameter, and distance to the primary bundle of the attached cylinder on the overall performance, and determine the optimal scheme. The results show that deposition in the cases using the mixed tube bundle strategy has significantly decreased. The weakening effects of the attached cylinder on the deposition of small-medium particles and large-sized particles are due to the inhibition of vortex development in the gap of tube bundle and the deviation of the motion trajectory, respectively. The novel design exhibits the lowest deposition mass M dep = 1.12 g and the best comprehensive performance PEC = 1.14 under the condition of the arrangement angle of 50°, the diameter of 10 mm, and the distance between the primary bundle of 5 mm. The obtained results can provide reference schemes and guidance for the optimization of the design of heat exchange equipment and accessory devices.

Numerical Investigation of Fly Ash Deposition onto Tube Bundles Inside Coal-Fired Boilers

A Numerical Simulation Study into the Effect of Longitudinal and Transverse Pitch on Deposition of Zhundong Coal Ash on Tube Bundles

A general mechanistic model of fly ash formation during pulverized coal combustion

STUDY ON WORN-OUT RESULTING FROM IMPACT OF FLY ASH PARTICLES ONTO SMOOTH TUBE BUNDLES WITH IN-LINE ARRANGEMENT

Dynamic Evolution of Impaction and Sticking Behaviors of Fly Ash Particle in Pulverized Coal Combustion

Numerical and Experimental Study on the Deposition of Fine Particulate Matter During the Combustion of Pulverized Lignite Coal in a 25 Kw Combustor

Numerical Simulation of Tube Erosion by Particle Impaction

Influences of vortices on impaction and distribution of small ash particles on rear side surface of boiler tube

Mechanisms and strategies for ash deposition reduction in flue gas heat exchanger

An Experimental Investigation into the Characteristics and Deposition Mechanism of High-Viscosity Coal Ash

Prediction and Validation of Ash Sticking Probability under Fouling Conditions in Pulverized Coal Combustion

Numerical study of solid particle erosion on sidewall

A Numerical Study of Ash Deposition Characteristics in a 660MW Supercritical Tangential Boiler

Study of Passage Rate of Flue Gas Particles Through Bundles of Smooth Tubes in Aligned Arrangement

Comprehensive evaluation on deposition and heat transfer performance of the mixed tube bundle based on orthogonal experimental study

NUMERICAL CALCULATION OF MULTIFACTORS AFFECTING PASSAGE RATE OF PARTICLES IN FLUE GAS ACROSS SMOOTHTUBE BUNDLES OF INLINE ARRANGEMENT

Numerical Study of Solid Particle Erosion on the Tubes Near the Side Walls in A Duct with Flow Past an Aligned Tube Bank

Numerical Simulation of Fly Ash Deposition in Coal and Corn Stalk Co-Combustion with Dynamic Mesh Technique

Numerical investigation on two-phase flow in rich/lean pulverized coal nozzles

Ash Deposition Characteristics on Heating Surface in Biomass Circulating Fluidized Bed Boiler

A MODEL FOR PREDICTING HEAT TRANSFER PROCESS WITH COAL ASH DEPOSITION IN UTILITY BOILERS