Abstract:The combined flue gas cooler with integrally-molded spiral finned (IMSF) tubes, which combines in-line and staggered tube bundles to leverage the performance advantages of different arrangement modes, has been proposed in this paper to simultaneously achieve heat transfer enhancement, ash deposition prevention, and wear resistance. The comprehensive performance including thermal–hydraulic, ash deposition, and wear performance of in-line and staggered IMSF tubes has not been reported and has been investigated with a multi-field coupled numerical model in this paper. Results show that for inline tubes, increasing the transverse pitch ( P T ) can reduce ash deposition and wear with slightly decrease in the thermal–hydraulic performance and increasing the longitudinal pitch ( P L ) can improve the thermal–hydraulic performance, with a significant increase in ash deposition when P L reaches to120mm, while for staggered tubes, decreasing the P T can enhance the thermal–hydraulic performance and reduce wear, with a sharp deterioration in ash deposition when the P T reaches 80 mm, and increasing the P L can decrease wear and has a minor impact on the thermal–hydraulic and ash deposition performance. Also, in the design of combined flue gas coolers, inline tubes should be placed at the front and two rows of dummy tubes placed before the inline tubes, and a larger P T and a moderate P L should be adopted to effectively reduces the overall tubes' wear and ash deposition; staggered tubes should be placed at the rear with an appropriate P T and a larger P L , enabling the full utilization of their excellent thermal–hydraulic performance while avoiding severe wear. This work can provide theoretical guidance and reference for the design and optimization of combined flue gas coolers to promote low-carbon emissions.

NUMERICAL CALCULATION OF MULTIFACTORS AFFECTING PASSAGE RATE OF PARTICLES IN FLUE GAS ACROSS SMOOTHTUBE BUNDLES OF INLINE ARRANGEMENT

Study of Passage Rate of Flue Gas Particles Through Bundles of Smooth Tubes in Aligned Arrangement

STUDY ON WORN-OUT RESULTING FROM IMPACT OF FLY ASH PARTICLES ONTO SMOOTH TUBE BUNDLES WITH IN-LINE ARRANGEMENT

Numerical Investigation of Fly Ash Deposition onto Tube Bundles Inside Coal-Fired Boilers

Mechanisms and strategies for ash deposition reduction in flue gas heat exchanger

NUMERICAL CALCULATIONS OF TUBE BUNDLES EROSION BY TURBULENT PARTICLE-LADEN GAS FLOWS

Heat transfer of tubes in gas-solid cross flow

Numerical study of particle deposition characteristics in a new type of reinforced pipe

To characterize two-phase flows around finned tube by using 3D-PDA and numerical calculation

Performance Improvement of a Circulating Fluidized Bed Boiler Through Flow Modifications in Primary Air Supply System

Performance comparison of inline and staggered integrally-molded spiral finned tubes for low-carbon emissions

Numerical Study of Solid Particle Erosion on the Tubes Near the Side Walls in A Duct with Flow Past an Aligned Tube Bank

Numerical Investigation On The Heat Transfer Enhancement Behavior Outside Longitudinal Finned Tubes

Comprehensive evaluation on deposition and heat transfer performance of the mixed tube bundle based on orthogonal experimental study

STUDY ON NUMERICAL SIMULATION OF DECREASING NOx EMISSION FROM COAL-FIRED BOILERS BASED ON BFA AND OFA

Numerical Simulation of Gas-particle Hydrodynamics in CFB

Numerical Study of a Power Plant Condenser Tube Arrangement

Numerical Simulation of Secondary Air Penetration Depth in a 300 MW Single-furnace Circulating Fluidized Bed Boiler

ANALYSIS OF THE EFFECT OF STOKES NUMBER AND INITIAL CONDITION ON THE DISPERSION CHARACTER FOR THE SOLID PARTICLES IN BOILER FURNACE

Numerical Simulation of the Impact of Secondary Air for a Pant-Leg 300 MW Circulation Fluidized Bed Boiler

Numerical Simulation of Fuel- Staged Burner in Tube Furnace