Abstract:The combined flue gas cooler with integrally-molded spiral finned (IMSF) tubes, which combines in-line and staggered tube bundles to leverage the performance advantages of different arrangement modes, has been proposed in this paper to simultaneously achieve heat transfer enhancement, ash deposition prevention, and wear resistance. The comprehensive performance including thermal–hydraulic, ash deposition, and wear performance of in-line and staggered IMSF tubes has not been reported and has been investigated with a multi-field coupled numerical model in this paper. Results show that for inline tubes, increasing the transverse pitch ( P T ) can reduce ash deposition and wear with slightly decrease in the thermal–hydraulic performance and increasing the longitudinal pitch ( P L ) can improve the thermal–hydraulic performance, with a significant increase in ash deposition when P L reaches to120mm, while for staggered tubes, decreasing the P T can enhance the thermal–hydraulic performance and reduce wear, with a sharp deterioration in ash deposition when the P T reaches 80 mm, and increasing the P L can decrease wear and has a minor impact on the thermal–hydraulic and ash deposition performance. Also, in the design of combined flue gas coolers, inline tubes should be placed at the front and two rows of dummy tubes placed before the inline tubes, and a larger P T and a moderate P L should be adopted to effectively reduces the overall tubes' wear and ash deposition; staggered tubes should be placed at the rear with an appropriate P T and a larger P L , enabling the full utilization of their excellent thermal–hydraulic performance while avoiding severe wear. This work can provide theoretical guidance and reference for the design and optimization of combined flue gas coolers to promote low-carbon emissions.

STUDY ON WORN-OUT RESULTING FROM IMPACT OF FLY ASH PARTICLES ONTO SMOOTH TUBE BUNDLES WITH IN-LINE ARRANGEMENT

NUMERICAL CALCULATION OF MULTIFACTORS AFFECTING PASSAGE RATE OF PARTICLES IN FLUE GAS ACROSS SMOOTHTUBE BUNDLES OF INLINE ARRANGEMENT

Numerical Investigation of Fly Ash Deposition onto Tube Bundles Inside Coal-Fired Boilers

Study of Passage Rate of Flue Gas Particles Through Bundles of Smooth Tubes in Aligned Arrangement

STUDY ON ELIMINATING FIRE-CARRYING IN PRIMARY AIR JET ORIFICE BY ADMIXING EXHAUST GAS

Numerical study of solid particle erosion on sidewall

A Numerical Simulation Study into the Effect of Longitudinal and Transverse Pitch on Deposition of Zhundong Coal Ash on Tube Bundles

Mechanisms and strategies for ash deposition reduction in flue gas heat exchanger

SIMULATION AND ANALYSIS ABOUT WORN-OUT ON CONNECTING PIPE OF LOW-PRESSURE REHEATER FOR A BOILER OF 600 MW UNIT

Numerical Study of Solid Particle Erosion on the Tubes Near the Side Walls in A Duct with Flow Past an Aligned Tube Bank

Study on Characteristics of CFBB Desulfurated Fly Ash and Pulverized Fly Ash

Design and Optimization of Air Pre-Heater with Internally Ribbed Tube

Performance comparison of inline and staggered integrally-molded spiral finned tubes for low-carbon emissions

Numerical investigation on ash accumulation characteristics of serrated spiral finned tube heat exchanger in waste heat utilization

On-site experimental study on fouling and heat transfer characteristics of flue gas heat exchanger for waste heat recovery

A Study of Practical Cooling Water-and Particulate Fouling Characteristics in Spiral-grooved Tubes

Numerical study of particle deposition characteristics in a new type of reinforced pipe

Influences of vortices on impaction and distribution of small ash particles on rear side surface of boiler tube

Dynamic CFD modeling evaluation of ash deposition behavior and morphology evolution with different tube arrangements

Study on the contamination coefficient of convective heating surface in a circulating fluidized bed boiler

Resident Time of Combustion Products and its Effect on Carbon Content in Fly Ash in Pulverized Coal Fired Boilers