Abstract:Particulate fouling on flue gas heat exchanger surfaces reduces heat transfer efficiency and increases the instability of equipment operation. It is necessary to develop a better understanding of how fouling occurs, aiming to find strategies to predict and reduce it. In this paper, a multiple mean cycle method is proposed based on a comprehensive fouling model considering the deposition and removal mechanisms, combined with the discrete phase model and dynamic mesh method, to predict the fouling morphology. Then the effects of transverse pitch, longitudinal pitch, tube shape and arrangement on fly-ash fouling and heat transfer characteristics are examined. It is found that, for aligned arrangement, the fly-ash particles are mainly deposited at the upwind stagnation region at the first row and whole windward side of the rest rows; for staggered arrangement, the fly-ash particles are deposited at the upwind stagnation region. The multiple mean cycle method can predict the fouling morphology efficiently and keep the characteristic of non-uniform fouling distribution. The fouling mass increases with the increase of relative transverse and longitudinal pitches. The elliptical tube bundle with small relative transverse and longitudinal pitches can obviously reduce the fouling mass especially for the staggered elliptical tube. Compared with the aligned circular tube arrangement, the fouling mass m(f) is decreased by 81.1% at 10 min. In addition, the weaken degree of Nusselt number after fouling Delta Nu for the staggered elliptical tube is only about 49.8% of the aligned circular tube arrangement. Consequently, using the staggered elliptical tube contributes to reduce the fly-ash fouling, decrease the soot-blowing frequency and ensure the efficiency, economy and safety of flue gas heat exchangers.

Study of Passage Rate of Flue Gas Particles Through Bundles of Smooth Tubes in Aligned Arrangement

NUMERICAL CALCULATION OF MULTIFACTORS AFFECTING PASSAGE RATE OF PARTICLES IN FLUE GAS ACROSS SMOOTHTUBE BUNDLES OF INLINE ARRANGEMENT

STUDY ON WORN-OUT RESULTING FROM IMPACT OF FLY ASH PARTICLES ONTO SMOOTH TUBE BUNDLES WITH IN-LINE ARRANGEMENT

A Parameter Study of Tube Bundle Heat Exchangers for Fouling Rate Reduction

Parametric Study on Fouling Mechanism and Heat Transfer Characteristics of Tube Bundle Heat Exchangers for Reducing Fouling Considering the Deposition and Removal Mechanisms

Numerical Investigation of Fly Ash Deposition onto Tube Bundles Inside Coal-Fired Boilers

A numerical study of high moisture flue gas in tube banks

Heat Transfer Characteristics of Air Cross-Flow for In-Line Arrangement of Spirally Corrugated Tube and Smooth Tube Bundles

Numerical Study on Shell- And-Tube Moving Packed Bed Heat Exchanger: Effect of Tube Arrangement on the Particle Side

Fouling and Thermal-Hydraulic Characteristics of Aligned Elliptical Tube and Honeycomb Circular Tube in Flue Gas Heat Exchangers

Flow Behavior of High-Temperature Flue Gas in the Heat Transfer Chamber of a Pilot-Scale Coal-Water Slurry Combustion Furnace

Comprehensive evaluation on deposition and heat transfer performance of the mixed tube bundle based on orthogonal experimental study

Experimental Research on Flow Field of Coal-water Slurry High Temperature Flue Gas Particle with Particle Image Velocimetry

Numerical study of particle deposition characteristics in a new type of reinforced pipe

Mechanisms and strategies for ash deposition reduction in flue gas heat exchanger

Experimental Study of Heat Transfer and Pressure Drop for H-type Finned Oval Tube with Longitudinal Vortex Generators and Dimples under Flue Gas

Numerical Study of Solid Particle Erosion on the Tubes Near the Side Walls in A Duct with Flow Past an Aligned Tube Bank

Heat Transfer Characteristic of Particle Flow Around the Out-Wall of Different Geometries

Numerical Investigation on Ash Fouling Characteristics of Flue Gas Heat Exchanger

Numerical investigation of flow stratification behavior of binary particle mixture for high-temperature flue gas filtration on an inclined moving bed

Simulation Study on Flow and Heat Transfer of Cross-Arrangement Tube Bundle