Abstract:Fouling deposition is dependent of deposit rate and removal rate, corresponding to sticking probability and deposit bond strength, respectively. As indicated by existing studies, heat transfer tubes with different geometries have different sticking probabilities. However, the effect of water velocity and the sticking probability have not been studied in depth. In this study, the particulate fouling on two internally enhanced tubes and a plain tube was tested at three water velocities for more than 500 h. As demonstrated by the experimental results, the asymptotic fouling resistance increased with the decrease in water velocity. According to the simulation result, the sticking probability was proportional to the surface temperature, which decreased with the increase in water velocity. Thus, it was indicated that the water velocity could have an effect on the characteristics of fouling deposition. Compared with the enhanced tubes, the plain tube with lower heat exchange capacity had a higher sticking probability, and it was more sensitive to the flow that had a significant effect on the deposit bond strength. Besides, the internal structure of enhanced tube had an effect on fouling deposition by changing the flow field near wall. The enhanced tube with the start-number of 45 had a lower sticking probability, compared with that with the start-number of 10. However, the particulate fouling on the enhanced tube with the start-number of 45 was hardly denuded by flow due to the larger deposit bond strength. With a focus on the water velocity, this study investigated the fouling mechanism, which can provide suggestions for designers to select heat transfer tubes with less fouling in accordance with operating conditions.

A Study of Practical Cooling Water-and Particulate Fouling Characteristics in Spiral-grooved Tubes

EXPERIMENTAL RESEARCH ON THE FOULING RESISTENT OF INTERNAL HELICAL-RIB TUBES

Numerical Analysis Of Cooling Tower Water Fouling In Enhanced Tubes

Analysis of Fouling in Six-Start Spirally Corrugated Tubes

Analysis on In-Several-Enhanced-Tubes Fouling Data Based on the Prandtle Analogy

Study on heat transfer and friction characteristics in fin-tube heat exchangers used for electrical machines cooling

Fouling model of internal helical-rib tubes based on prandtle analogy

Analysis of Fouling Characteristic in Enhanced Tubes Using Multiple Heat and Mass Transfer Analogies

Analysis of Cooling Tower Fouling in Enhanced Tubes Based on the Prandtl Analogy

Modeling Particulate Fouling in Internal Helical-Rib Tubes by Von-Karman Analogy

Analysis of in Tubes Particulate Fouling Characteristic

The Performances of Internal Helical-Rib Roughness Tubes under Fouling Conditions: Practical Cooling Tower Water Fouling and Accelerated Particulate Fouling

Modeling liquid-side particulate fouling in internal helical-rib tubes

Experimental study on the fouling and heat transfer characteristics of enhanced tubes used in a cooling tower water system with the actual water quality

Fouling in enhanced tubes using cooling tower water: Part II: combined particulate and precipitation fouling

Fouling characteristics of internal helical-rib roughness tubes using low-velocity cooling tower water

Heat transfer and fouling characteristics during falling film evaporation in a vertical sintered tube

Investigation on the fouling mechanism at different water velocities in internally enhanced tubes

Thermohydraulic analysis of hybrid smooth and spirally corrugated tubes

Analysis of Fouling Characteristic in Enhanced Tubes Using Multiple Analogies

Heat Transfer and Fouling Performance During Falling Film Evaporation in Vertical Porous Tubes