Abstract:Fouling is one of the most significant problems for internally enhanced tubes installed in the shell and tube condensers. Due to the lack of long-term test data, current fouling models are developed based on accelerated particulate fouling tests that have the low precision and hence are inapplicable for predicting combined fouling in most practical cooling tower systems. In addition, the constant values of fouling resistance (factor) recommended by the Air-Conditioning, Heating, and Refrigeration Institute (AHRI) are extremely limited under different operating conditions. To overcome these challenges, this research developed and validated two fouling prediction models based on experimental long-term tests. One of the models was in the form of a ratio of asymptotic fouling resistance of the enhanced tube to that of the plain tube (<math>Rf∗/Rf,p∗</math>), and the other one was in the form of the asymptotic fouling resistance of the directly enhanced tube (<math>Rf∗</math>). Both models considered water quality, water velocity, and the tube geometries as the variables with the acceptable accuracy for prediction. 1) For the water quality, the parameter of valid concentration (<math>Ccom</math>) of cooling water was defined in this study, which reflected the potential amount of valid components to form the fouling. 2) For the water velocity, its impacts on the two critical parameters of the fouling process: sticking probability (<math>P</math>) and deposit bond strength (<math>ξ</math>) were investigated using experimental studies. Test results showed that in enhanced tubes with the increased water velocity the sticking probability (<math>P</math>) decreased continuously while the deposit bond strength (ξ) initially increased, and then, decreased. 3) For the tube geometries, by taking the parameters of tube geometries as variables the multi-variable correlations of the sticking probability (<math>P</math>) and deposit bond strength (<math>ξ</math>) were developed. From the results the generalized fouling prediction model as a ratio of asymptotic fouling resistance (<math>Rf∗/Rf,p∗</math>) was recommended for the application in HVAC&R industry due to its suitability and accuracy in practical project applications.

Investigation on the fouling mechanism at different water velocities in internally enhanced tubes

Experimental study on the fouling and heat transfer characteristics of enhanced tubes used in a cooling tower water system with the actual water quality

Experimental study on long-term fouling of enhanced tubes: Effect of water quality

Experimental study on the sticking probability and deposit bond strength of fouling in enhanced tubes

Investigation on fouling of enhanced tubes used in a cooling tower water system based on a long-term test

Analysis of in Tubes Particulate Fouling Characteristic

Analysis on In-Several-Enhanced-Tubes Fouling Data Based on the Prandtle Analogy

Numerical Analysis Of Cooling Tower Water Fouling In Enhanced Tubes

Analysis of Fouling in Six-Start Spirally Corrugated Tubes

Analysis of Fouling Characteristic in Enhanced Tubes Using Multiple Heat and Mass Transfer Analogies

Modeling Particulate Fouling in Internal Helical-Rib Tubes by Von-Karman Analogy

An Improved Modeling Method of Water-side Fouling in Enhanced Tubes of Condensers in Application of Cooling Water Tower

Local deposition characteristics of calcium carbonate fouling in different enhanced tubes

Experimental Study of the Fouling Characteristics in a Pilot-Scale Facility: Influence of the Fouling Surface

Modeling liquid-side particulate fouling in internal helical-rib tubes

A Study of Practical Cooling Water-and Particulate Fouling Characteristics in Spiral-grooved Tubes

Heat transfer and fouling characteristics during falling film evaporation in a vertical sintered tube

Numerical study of particle deposition characteristics in a new type of reinforced pipe

A generalized prediction model of waterside fouling for internally enhanced tubes in shell and tube condensers

Fouling in enhanced tubes using cooling tower water: Part II: combined particulate and precipitation fouling

Analysis of Fouling Characteristic in Enhanced Tubes Using Multiple Analogies