Simulation of the Lateral Movement on Particles Under Continuous Feeding and Discharging in a CFB Dense Zone

ZHANG Xian,GE Rongcun,CAI Runxia,SHEN Wenfeng,ZHANG Shouyu,LIU Qing,LI Ruixin
DOI: https://doi.org/10.13334/j.0258-8013.pcsee.171558
2018-01-01
Abstract:Under continuous feeding and discharging conditions,the influence of bed material size distribution and fiuidization velocities on gas-solid two-phase flow structure,lateral motion and residence time of particles were investigated by computation particle fluid dynamics (CPFD) method,which is a discrete element method (DEM).The model size was 900 mm×100 mm×1 200 mm.The results show that the bed height in right side is lower in left side and a dead zone existed above the bottom ash discharging port.With the increase of fluidization velocity,the difference of bed height and the size of dead zone decrease,and the dispersion of residence time distribution increases.The bed expansion also increases with the fluidization velocity,but the increasing extent decreases when the fluidization velocity exceeds a certain limit.However,the average residence time of particles in the bed is non-monotonic,which firstly reduces,then increases and finally unchange.At the same fluidization velocity,the results of mono-size particle essentially are similar to those of multi-size particles ranging from 0.3 mm to 0.6 mm,but for multi-size particles ranging from 0.6 mm to 1.5mm,the average residence time is larger and the residence time distribution is more concentrated.
What problem does this paper attempt to address?