Abstract:This study attempts to clarify the correlation between the structural parameters of vortex finders (diameter ratio and insertion depth) and the strong turbulent flow field and performance of cyclone separators. To elucidate the effects due to the overflow pipe diameter, insertion depth, and Reynolds number on the tangential velocity index (n) and separation efficiency, 0.3D, 0.4D, 0.5D, 0.6D, and 0.7D (where D is the diameter of the cyclone separator’s cylindrical section) were selected as the vortex finder diameter and insertion depth, which were studied using three methods: computational fluid dynamics (CFD) software Fluent, experiments, and artificial neural network simulations. With Fluent, the Reynolds stress model (RSM) of turbulence was adopted to describe transport equations, and the discrete phase model (DPM) for two-phase flow was used to calculate the efficiency and separate particles at different inlet velocities. Experiments were conducted to measure the operational pressure drop and separation efficiency of the system; subsequently, the results were used to validate the CFD calculation results. Finally, a 5–5-1 three-layer artificial neural network was established based on 336 sets of data for values of n obtained from numerical simulations. In addition, a backpropagation (BP) artificial neural network model was employed to predict the correlation between the structural and operational parameters of the cyclone separator and n values. The obtained results indicate that the BP artificial neural network can accurately predict the distribution of n values within the flow field of the cyclone. Increasing the diameter of the vortex finder with the same inlet velocity can reduce the total pressure drop due to the cyclone, thereby reducing the kinetic energy loss and improving the separation efficiency of fine particles. Increasing the insertion depth of the vortex finder leads to an increase in the values of n. Considering the stability of the flow field structure and energy dissipation, an S/D value between 0.5 and 0.6 is preferred.

Influence of nose angle on performance of dense medium cyclones with volute inlet

Performance Evaluation of a New Micro Gas Cyclone Using Simulation and Experimental Studies to Capture Indoor Fine Particles

Study on Separation Performance of Tri-Cone Water Medium Cyclone Based on CFD

Micro Gas Cyclone Design and Performance Evaluation to Collect Dust Particles

Prediction of medium-to-coal ratio effect in a dense medium cyclone by using both traditional and coarse-grained CFD-DEM models

Influence of Cyclone Combustor Structure on the Motion Behaviors of Solid Fuel Particles

Effects of the Inlet Duct Length on the Performance of a Dense Medium Cyclone: an Experimental and Numerical Study

Numerical investigation of hydrocyclone inlet configurations for improving separation performance

Multi-objective optimization of a novel vortex finder for performance improvement of cyclone separator

Study on the floatation mechanism and floatation performance for the floatation cyclone of natural inlet air

Numerical simulation of the particle-wall collision strength and swirling effect on the performance of the axial flow cyclone separator

Development of an integrated multichannel inlet for improved particle classification in hydrocyclones

Simulation and experimental study of effect of vortex finder structural parameters on cyclone separator performance

Classification Performance of Model Coal Mill Classifiers with Swirling and Non-Swirling Inlets

Numerical study on the performance of swirl tube based on orthogonal design

Particle size-included partition curve model of dense medium cyclones

Performance experiments and pressure drop prediction modelling of an energy-saving cyclone separator

Numerical analysis of cyclone separators with unique Dipleg structures at different Dipleg-to-dustbin ratios

Experimental and computational fluid dynamics study on the effects of erosion spiral angle of the cone on cyclone separator performance

An Experimental Study of the Structural Optimization of Square Shaped Cyclone Separators

CFD Investigation on the Performance of Cyclone Separators with Divergent or Convergent Insertion Pipes