Abstract:Dense medium cyclones (DMCs) are widely used in coal mine sorting processes to improve the quality of coal products and reduce pollution. The conventional linear inlet DMCs has the problems of unstable flow field, high turbulence density and low separation efficiency. Based on these concerns, the volute inlet DMCs was proposed, however the nose angle as one of the most critical parameters has not yet been investigated in depth. In this paper, a DMC with volute inlet is investigated, and the effect of nose angle is studied by a computational fluid dynamics model in terms of flow field, particle motion and the forces acting on the particles. The performance of the DMC is evaluated with respect to the inlet nose angle. As the nose angle increases from 0 to 180 deg., the separation efficiency has a tendency to increase and then decrease with the inflection point founding when nose angle is 180 deg. Then the flow field, particle distribution and particle force are analyzed respectively. The results show that the symmetry and stability of the flow field can be significantly improved as nose angle increases from 0 to 180 deg., but they remain almost constant when nose angle is 270°. In addition, a quantification method of the short-circuiting flow is established and it has been found that increasing the nose angle can notably reduce the short-circuiting flow. In terms of particle phase, increasing the nose angle causes heavier particle distribution tends to concentrate. During this period, the variation pattern of forces on particles with different nose angles is also analyzed. The DMC with a nose angle of 180 deg. has a longer acceleration zone at the entrance height and an increased radial force on the particles, which results in better performance. This study provides a theoretical basis and reference for the structure optimization of dense medium cyclones.

Prediction of medium-to-coal ratio effect in a dense medium cyclone by using both traditional and coarse-grained CFD-DEM models

Prediction of the performance of dense medium cyclones in coal preparation

Studying on the Upper Limit of the Coarse-Grained DEM Model for Simulating Mixing Processes in a Rolling Drum with Complex Wall Boundary

Particle size-included partition curve model of dense medium cyclones

CFD-DEM Study on the Synergistic Effect of Coke Consumption and Particle Dynamics in the Blast Furnace Raceway

CFD-DEM Simulation of Fluidized Bed with an Immersed Tube Using a Coarse-Grain Model

Development and Verification of Coarse‐grain CFD‐DEM for Nonspherical Particles in a Gas–solid Fluidized Bed

Influence of nose angle on performance of dense medium cyclones with volute inlet

Influence of Cyclone Combustor Structure on the Motion Behaviors of Solid Fuel Particles

CFD-DEM Simulation of Flow and Mixing Behavior in Downers with Different Entrance Structures

Coarse-grained CFD-DEM simulation to determine the multiscale characteristics of the air dense medium fluidized bed

CFD-DEM Modeling of Rod-Like Particles in a Fluidized Bed with Complex Geometry

A hybrid multiphase model accounting for particle agglomeration for coarse-grid simulation of dense solid flow inside large-scale cyclones

Verification of coarse-grained CFD-DEM method in multiple flow regimes

CFD-DDPM coupled with an agglomeration model for simulation of highly loaded large-scale cyclones: Sensitivity analysis of sub-models and model parameters

Numerical Study on the Effect of Fine Coal Accumulation in a Coal Beneficiation Fluidized Bed

CFD-DEM Study of the Effect of Cyclone Arrangements on the Gas-Solid Flow Dynamics in the Full-Loop Circulating Fluidized Bed

Modeling and validation of coarse-grained computational fluid dynamics–discrete element method for dense gas–solid flow simulation in a bubbling fluidized bed

Development and verification of coarse‐grain CFD‐DEM for non‐spherical particles in a gas‐solid fluidized bed

Predictions of Coal Combustion and Desulfurization in a CFB Riser Reactor by Kinetic Theory of Granular Mixture with Unequal Granular Temperature

Study on tribocharging of CaCO3 particles based on CFD-DEM gas-solid two-phase flow coupling