Abstract:Dense medium cyclones (DMCs) are widely used in coal mine sorting processes to improve the quality of coal products and reduce pollution. The conventional linear inlet DMCs has the problems of unstable flow field, high turbulence density and low separation efficiency. Based on these concerns, the volute inlet DMCs was proposed, however the nose angle as one of the most critical parameters has not yet been investigated in depth. In this paper, a DMC with volute inlet is investigated, and the effect of nose angle is studied by a computational fluid dynamics model in terms of flow field, particle motion and the forces acting on the particles. The performance of the DMC is evaluated with respect to the inlet nose angle. As the nose angle increases from 0 to 180 deg., the separation efficiency has a tendency to increase and then decrease with the inflection point founding when nose angle is 180 deg. Then the flow field, particle distribution and particle force are analyzed respectively. The results show that the symmetry and stability of the flow field can be significantly improved as nose angle increases from 0 to 180 deg., but they remain almost constant when nose angle is 270°. In addition, a quantification method of the short-circuiting flow is established and it has been found that increasing the nose angle can notably reduce the short-circuiting flow. In terms of particle phase, increasing the nose angle causes heavier particle distribution tends to concentrate. During this period, the variation pattern of forces on particles with different nose angles is also analyzed. The DMC with a nose angle of 180 deg. has a longer acceleration zone at the entrance height and an increased radial force on the particles, which results in better performance. This study provides a theoretical basis and reference for the structure optimization of dense medium cyclones.

Particle size-included partition curve model of dense medium cyclones

Prediction of medium-to-coal ratio effect in a dense medium cyclone by using both traditional and coarse-grained CFD-DEM models

Prediction of the performance of dense medium cyclones in coal preparation

Numerical studies of the influence of particles' size distribution characteristics on the gravity separation performance of Liquid-solid Fluidized Bed Separator

A hybrid multiphase model accounting for particle agglomeration for coarse-grid simulation of dense solid flow inside large-scale cyclones

Influence of nose angle on performance of dense medium cyclones with volute inlet

Simulation and optimization of the particle agglomeration in an aerodynamic agglomerator using a CFD-PBM coupled model

Influence of Cyclone Combustor Structure on the Motion Behaviors of Solid Fuel Particles

CFD-DEM Investigation of the Fluidization of Binary Mixtures Containing Rod-Like Particles and Spherical Particles in a Fluidized Bed

Numerical analysis of cyclone separators with unique Dipleg structures at different Dipleg-to-dustbin ratios

Modelling of Dense Gas-Particle Flow in a Circulating Fluidized Bed by Distinct Cluster Method (DCM)

Model of coal slime combustion behavior in CFB boiler

Simulation of cyclone separator using multiphase particle in cell method based on particle energy dissipation model

Comparison of Separation Performance of Liquid-Solid Fluidized Bed Separator and Dense Medium Cyclone for Cleaning Coal

A Feed-regulated Water-only Cyclone for Improving the Separation Performance of Clean Coal from Coal Slime

Gas-Particle Cyclonic Separation Dynamics: Modeling and Characterization

Transport Hydrodynamics of Particles in a Gas–solid Cyclone Reactor Using a Dense Discrete Phase Model and a Particle Size Segmentation Method

A Mathematic Model Based on Edlvo and Lifshitz Theory Calculating Interparticle Interactions in Coal Water Slurry

Particle Migration Regularity in Compound Force Field of Enhanced Gravity Concentrator

Numerical Study of Particle Segregation in a Coal Beneficiation Fluidized Bed by a TFM–DEM Hybrid Model: Influence of Coal Particle Size and Density

Hydrodynamic Model with Binary Particle Diameters to Predict Axial Voidage Profile in a CFB Combustor