Abstract:This study attempts to clarify the correlation between the structural parameters of vortex finders (diameter ratio and insertion depth) and the strong turbulent flow field and performance of cyclone separators. To elucidate the effects due to the overflow pipe diameter, insertion depth, and Reynolds number on the tangential velocity index (n) and separation efficiency, 0.3D, 0.4D, 0.5D, 0.6D, and 0.7D (where D is the diameter of the cyclone separator’s cylindrical section) were selected as the vortex finder diameter and insertion depth, which were studied using three methods: computational fluid dynamics (CFD) software Fluent, experiments, and artificial neural network simulations. With Fluent, the Reynolds stress model (RSM) of turbulence was adopted to describe transport equations, and the discrete phase model (DPM) for two-phase flow was used to calculate the efficiency and separate particles at different inlet velocities. Experiments were conducted to measure the operational pressure drop and separation efficiency of the system; subsequently, the results were used to validate the CFD calculation results. Finally, a 5–5-1 three-layer artificial neural network was established based on 336 sets of data for values of n obtained from numerical simulations. In addition, a backpropagation (BP) artificial neural network model was employed to predict the correlation between the structural and operational parameters of the cyclone separator and n values. The obtained results indicate that the BP artificial neural network can accurately predict the distribution of n values within the flow field of the cyclone. Increasing the diameter of the vortex finder with the same inlet velocity can reduce the total pressure drop due to the cyclone, thereby reducing the kinetic energy loss and improving the separation efficiency of fine particles. Increasing the insertion depth of the vortex finder leads to an increase in the values of n. Considering the stability of the flow field structure and energy dissipation, an S/D value between 0.5 and 0.6 is preferred.

An Experimental Study of the Structural Optimization of Square Shaped Cyclone Separators

Effect of Height to Width Ratio at Entrance and of the Straight Section's Height on the Performance of Rectangular Shaped Cyclone Separators

Influence of Inlet Structure on Separation Efficiency of Cyclone Separators

Design of Multi-Stage Contracted Inlet Duct for Cyclone Separators

Width of Accelerating Inlet of Square Cyclone

Research on structural parameter optimization of a new axial inlet hydrocyclone separator based on response surface optimization method

ICONE19-43328 PERFORMANCE ANALYSIS OF CYCLONE SEPARATOR AND ITS OPTIMIZATION

Simulation and experimental study of effect of vortex finder structural parameters on cyclone separator performance

Multi-objective optimization of a novel vortex finder for performance improvement of cyclone separator

Investigation of Velocity of Square Cyclone with Accelerating Inlet

Investigation on separation performance and structural optimization of a two-stage series cyclone using CPFD and RSM

Numerical analysis of cyclone separators with unique Dipleg structures at different Dipleg-to-dustbin ratios

Enhancing the efficiency of two‐stage cyclones without increasing pressure drop by optimizing inlet and outlet dimensions

Numerical simulation of the particle-wall collision strength and swirling effect on the performance of the axial flow cyclone separator

Performance experiments and pressure drop prediction modelling of an energy-saving cyclone separator

AN EXPERIMENTAL STUDY ON THE GAS-SOLID TWO-PHASE FLOW IN A SQUARE CYCLONE SEPARATOR WITH DOWNWARD GAS EXIT BY 3D-PDA

Numerical study on the performance of swirl tube based on orthogonal design

Influence of Cyclone Combustor Structure on the Motion Behaviors of Solid Fuel Particles

Experimental Study of the Separation Performance of a Square Separator Assuming a Horizontal Heat Exchange Mode

CFD Investigation on the Performance of Cyclone Separators with Divergent or Convergent Insertion Pipes

Experimental study on a new type of cyclone separator for fine particles