Abstract:The development of a radial-inlet structure cyclone separator is reported in this paper, which is used as a primary device for gas-particle separation in an opposed multi-burner (OMB) gasification system. The radial-inlet cyclone is more suitable for a high-pressure industrial operation environment on the premise of higher efficiency. A model based on computational fluid dynamics (CFD) techniques was applied to study the performance of a new-type cyclone separator In the approach, the turbulent flow was described by the Reynolds stress model, and the particle flow was described by the stochastic Lagrangian model. The validity of the proposed approach is verified by the good agreement between the measured and the predicted results. The results indicate that, though the velocity flow field is not geometry symmetrical and a three-dimensional unsteady state, it is quasi-periodic. Additionally, there exists a processing vortex core phenomenon in the cyclone. The particle concentration distribution is nonuniform because of the centrifugal force The distribution area can be divided into three parts according to the particles' motion feature And the larger particles are easier to separate than the smaller ones. But particles with a size exceeding a critical value will not be collected at the bottom and stagnate on the conical wall of the cyclone. This will lead to serious erosion on the conical part in the cyclone. In addition, the separation efficiency increases with the particle size, and the cut-point diameter of the radial-inlet cyclone is smaller than the traditional cyclone under the same inlet conditions.

Investigation of Velocity of Square Cyclone with Accelerating Inlet

Width of Accelerating Inlet of Square Cyclone

Numerical Simulating the Gas-solid Flow in Square Cyclone With a Curved Inlet

Micro Gas Cyclone Design and Performance Evaluation to Collect Dust Particles

Performance Evaluation of a New Micro Gas Cyclone Using Simulation and Experimental Studies to Capture Indoor Fine Particles

The Performance Prediction of the Scaling Up Square Cyclone with Particle Accelerating Inlet

Experimental study on the gas-solid two-phase flow in a square cyclone separator with downward gas exit by particle dynamic analyzer

An Experimental Study of the Structural Optimization of Square Shaped Cyclone Separators

Instantaneous Separation Model of a Square Cyclone

AN EXPERIMENTAL STUDY ON THE GAS-SOLID TWO-PHASE FLOW IN A SQUARE CYCLONE SEPARATOR WITH DOWNWARD GAS EXIT BY 3D-PDA

Instantaneous separation model of a square cyclone1Supported by the National Natural Science Foundation.1

Influence of Inlet Structure on Separation Efficiency of Cyclone Separators

Numerical study of gas-solid flow in a radial-inlet structure cyclone separator

Numerical Study of Gas-Solid Flow in a Square Cyclone Separator with Different Vortex Finders

Effect of inlet periodic velocity on the performance of standard cyclone separators

Experimental Research on Square Cyclone

Experimental Research on Separation Performance for Square Cyclone Separator under Different Constructional Details

A study on gas flow in spiral inlet cyclone separator

Experimental investigation on separation characteristics of axial cyclone separator

Numerical modeling of body shape effect on the performance of a square cyclone separator

Effects of the inlet particle spatial distribution on the performance of a gas-solid cyclone separator