Abstract:This study attempts to clarify the correlation between the structural parameters of vortex finders (diameter ratio and insertion depth) and the strong turbulent flow field and performance of cyclone separators. To elucidate the effects due to the overflow pipe diameter, insertion depth, and Reynolds number on the tangential velocity index (n) and separation efficiency, 0.3D, 0.4D, 0.5D, 0.6D, and 0.7D (where D is the diameter of the cyclone separator’s cylindrical section) were selected as the vortex finder diameter and insertion depth, which were studied using three methods: computational fluid dynamics (CFD) software Fluent, experiments, and artificial neural network simulations. With Fluent, the Reynolds stress model (RSM) of turbulence was adopted to describe transport equations, and the discrete phase model (DPM) for two-phase flow was used to calculate the efficiency and separate particles at different inlet velocities. Experiments were conducted to measure the operational pressure drop and separation efficiency of the system; subsequently, the results were used to validate the CFD calculation results. Finally, a 5–5-1 three-layer artificial neural network was established based on 336 sets of data for values of n obtained from numerical simulations. In addition, a backpropagation (BP) artificial neural network model was employed to predict the correlation between the structural and operational parameters of the cyclone separator and n values. The obtained results indicate that the BP artificial neural network can accurately predict the distribution of n values within the flow field of the cyclone. Increasing the diameter of the vortex finder with the same inlet velocity can reduce the total pressure drop due to the cyclone, thereby reducing the kinetic energy loss and improving the separation efficiency of fine particles. Increasing the insertion depth of the vortex finder leads to an increase in the values of n. Considering the stability of the flow field structure and energy dissipation, an S/D value between 0.5 and 0.6 is preferred.

Influence of Inlet Structure on Separation Efficiency of Cyclone Separators

An Experimental Study of the Structural Optimization of Square Shaped Cyclone Separators

Study on Separation Performance of Tri-Cone Water Medium Cyclone Based on CFD

Influence of Cyclone Combustor Structure on the Motion Behaviors of Solid Fuel Particles

ICONE19-43328 PERFORMANCE ANALYSIS OF CYCLONE SEPARATOR AND ITS OPTIMIZATION

Investigation of Velocity of Square Cyclone with Accelerating Inlet

Design of Multi-Stage Contracted Inlet Duct for Cyclone Separators

Numerical Simulating the Gas-solid Flow in Square Cyclone With a Curved Inlet

CFD Investigation on the Performance of Cyclone Separators with Divergent or Convergent Insertion Pipes

Simulation and experimental study of effect of vortex finder structural parameters on cyclone separator performance

The Performance Prediction of the Scaling Up Square Cyclone with Particle Accelerating Inlet

Width of Accelerating Inlet of Square Cyclone

Numerical analysis of cyclone separators with unique Dipleg structures at different Dipleg-to-dustbin ratios

Effect of inlet periodic velocity on the performance of standard cyclone separators

Numerical Investigation of Inlet Height and Width Variations on Separation Performance and Pressure Drop of Multi-Inlet Cyclone Separators

Performance Analysis of Gas-Liquid Cylindrical Cyclone （GLCC） Separator with an Inclined and Perforated Wall

Study of the performance and flow field of a new spiral-roof cyclone separator

Numerical investigation of hydrocyclone inlet configurations for improving separation performance

Study on the floatation mechanism and floatation performance for the floatation cyclone of natural inlet air

Experimental investigation on separation characteristics of axial cyclone separator

Numerical simulation of gas-solid flow in a cyclone separator with additional inlet