Abstract:The classification performance of model coal mill classifiers with different bottom incoming flow inlets was experimentally and numerically studied. The flow field adjacent to two neighboring impeller blades was measured using the particle image velocimetry technique. The results showed that the flow field adjacent to two neighboring blades with the swirling inlet was significantly different from that with the non-swirling inlet. With the swirling inlet, there was a vortex located between two neighboring blades, while with the non-swirling inlet, the vortex was attached to the blade tip. The vorticity of the vortex with the non-swirling inlet was much lower than that with the swirling inlet. The classifier with the non-swirling inlet demonstrated a larger cut size than that with the swirling inlet when the impeller was stationary (similar to 0 r.min(-1)). As the impeller rotational speed increased, the cut size of the cases with non-swirling and swirling inlets both decreased, and the one with the non-swirling inlet decreased more dramatically. The values of the cut size of the two classifiers were close to each other at a high impeller rotational speed (>= 120 r.min(-1)). The overall separation efficiency of the classifier with the non-swirling inlet was lower than that with the swirling inlet, and monotonically increased as the impeller rotational speed increased. With the swirling inlet, the overall separation efficiency first increased with the impeller rotational speed and then decreased when the rotational speed was above 120 r.min(-1), and the variation trend of the separation efficiency was more moderate. As the initial particle concentration increased, the cut sizes of both swirling and non-swirling inlet cases decreased first and then barely changed. At a low initial particle concentration (<0.04 kg.m(-3)), the classifier with the swirling inlet had a larger cut size than that with the non-swirling inlet. (C) 2019 The Chemical Industry and Engineering Society of China, and Chemical Industry Press Co., Ltd. All rights reserved.

CFD simulation and performance optimization of a new horizontal turbo air classifier

Numerical Simulation of a Flow Field in a Turbo Air Classifier and Optimization of the Process Parameters

Performance Evaluation of a New Micro Gas Cyclone Using Simulation and Experimental Studies to Capture Indoor Fine Particles

Orthogonal vortices characteristic, performance evaluation and classification mechanism of a horizontal classifier with three rotor cages

The influence of air inlet layout on the inner flow field for a vertical turbo air classifier

Numerical Simulation Analysis of Ultrafine Powder Centrifugal Classifier

Multi-objective optimization of a novel vortex finder for performance improvement of cyclone separator

Experimental Study on Velocity Field Between Two Adjacent Blades and Gas–solid Separation of a Turbo Air Classifier

Vortex analysis and flow field optimization for the particle classifier with three rotary cages

Structure optimization of rotor cage blades for turbo air classifier based on entropy production analysis

Effects of a Guide Cone on the Flow Field and Performance of a New Dynamic Air Classifier

Classification Performance of Model Coal Mill Classifiers with Swirling and Non-Swirling Inlets

Numerical Simulation Study of a Pusher Feed Classifier Based on RNG-DPM Method

Multi-objective optimization of axial-flow-type gas-particle cyclone separator using response surface methodology and computational fluid dynamics

A Numerical Study on the Flow Field and Classification Performance of an Industrial-Scale Micron Air Classifier under Various Outlet Mass Airflow Rates

Particle Classification Optimization of a Circulating Air Classifier

Enhancement of the classification and recovery process of fine mineral particles via a newly developed volute feed hydrocyclone

Influence of guide vane on dispersion of aggregates near the guide vane in a turbo air classifier

Investigation on separation performance and structural optimization of a two-stage series cyclone using CPFD and RSM

Numerical simulation of the particle-wall collision strength and swirling effect on the performance of the axial flow cyclone separator

Performance analysis of the cyclone separator with a novel clean air inlet installed on the roof surface