Abstract:The classification performance of model coal mill classifiers with different bottom incoming flow inlets was experimentally and numerically studied. The flow field adjacent to two neighboring impeller blades was measured using the particle image velocimetry technique. The results showed that the flow field adjacent to two neighboring blades with the swirling inlet was significantly different from that with the non-swirling inlet. With the swirling inlet, there was a vortex located between two neighboring blades, while with the non-swirling inlet, the vortex was attached to the blade tip. The vorticity of the vortex with the non-swirling inlet was much lower than that with the swirling inlet. The classifier with the non-swirling inlet demonstrated a larger cut size than that with the swirling inlet when the impeller was stationary (similar to 0 r.min(-1)). As the impeller rotational speed increased, the cut size of the cases with non-swirling and swirling inlets both decreased, and the one with the non-swirling inlet decreased more dramatically. The values of the cut size of the two classifiers were close to each other at a high impeller rotational speed (>= 120 r.min(-1)). The overall separation efficiency of the classifier with the non-swirling inlet was lower than that with the swirling inlet, and monotonically increased as the impeller rotational speed increased. With the swirling inlet, the overall separation efficiency first increased with the impeller rotational speed and then decreased when the rotational speed was above 120 r.min(-1), and the variation trend of the separation efficiency was more moderate. As the initial particle concentration increased, the cut sizes of both swirling and non-swirling inlet cases decreased first and then barely changed. At a low initial particle concentration (<0.04 kg.m(-3)), the classifier with the swirling inlet had a larger cut size than that with the non-swirling inlet. (C) 2019 The Chemical Industry and Engineering Society of China, and Chemical Industry Press Co., Ltd. All rights reserved.

Structure optimization of rotor cage blades for turbo air classifier based on entropy production analysis

CFD simulation and performance optimization of a new horizontal turbo air classifier

Statistical Investigations of Profile Error Impact on Flow and Performance of a Low-Pressure Turbine Cascade

Numerical Simulation of a Flow Field in a Turbo Air Classifier and Optimization of the Process Parameters

Experimental Study on Velocity Field Between Two Adjacent Blades and Gas–solid Separation of a Turbo Air Classifier

The influence of air inlet layout on the inner flow field for a vertical turbo air classifier

Orthogonal vortices characteristic, performance evaluation and classification mechanism of a horizontal classifier with three rotor cages

Numerical Simulation Analysis of Ultrafine Powder Centrifugal Classifier

Characteristics of Differential Entropy Generation in a Transonic Rotor and Its Applications to Casing Treatment Designs

Optimization Design of Aspect Ratio and Solidity of a Heavy-Duty Gas Turbine Transonic Compressor Rotor

Vortex analysis and flow field optimization for the particle classifier with three rotary cages

Experimental and CFD analysis on the pressure ratio and entropy increment in a cover-plate pre-swirl system of gas turbine engine

Numerical Analysis of Unsteady Phenomena in a Contra-Rotating Stage Based On the Reduction of Local Entropy Production

Research of Impact of Cooling on Entropy Creation and Turbine Efficiency

Numerical Study on Local Entropy Production Mechanism of a Contra-Rotating Fan

Optimization of the Blade Trailing Edge Geometric Parameters for A Small Scale Orc Turbine

Investigation of aerodynamic loss mechanism on turbine leading edge with slot film cooling based on entropy analysis

Classification Performance of Model Coal Mill Classifiers with Swirling and Non-Swirling Inlets

Multiobjective Optimization Study On the Aerodynamic Performance and Anti-Erosion Characteristics of a Single-Stage Dusty Flue Gas Turbine

Computational investigation of the aerodynamics of automotive turbocharger mixed-flow turbines

Design Optimization and Analysis of Exit Rotor with Diffuser Passage based on Neural Network Surrogate Model and Entropy Generation Method