Abstract:In this study, combustion synthesis involving mechanical milling and subsequent sintering process was utilised to fabricate Cu/AlxCuy/Al2O3 in-situ composite through the aluminothermic reduction of CuO powders. First, CuO and Al powders were mixed, and ball milled for 30–150 min to facilitate self-propagating high-temperature synthesis (SHS). Then, mechanically activated Al-CuO powders were mixed with elemental Cu powders and experienced subsequent cold compaction and sintering processes. The reactions during synthesis were studied utilising differential thermal analysis (DTA), X-ray diffraction (XRD), and scanning electron microscopy (SEM). Densification and hardness of green and sintered bodies were also obtained. The results indicated that despite the negative free energy of the aluminothermic reaction, an initial activation energy supply is required, and mixed Al-CuO powders did not show significant progress in the combustion synthesis method. The aluminothermic reaction became probable whenever the activation energy was entirely provided by high-energy ball milling or by the sintering of ball-milled Al-CuO mixed powders. DTA results showed that the aluminothermic reaction temperature of Al-CuO decreased with milling times, whereas after 150 min of ball milling, the reaction was completed. XRD patterns revealed that the formation of Al2Cu and Al2O3 reinforcing phases resulted from CuO reduction with Al. Al4Cu9, Cu solid solution, and Al oxide phases were observed in sintered samples. The relative density of the samples was reduced compared to the green compacted parts due to the nature of the Cu-Al alloy and the occurrence of the swelling phenomenon. The hardness results indicated that in-situ formation of reinforcing phases in samples that experienced thermally assisted thermite reaction yielded superior hardness.

Reduction reaction in Al-CuO powder mixture driven by mechanical alloying

Nanostructured Composite Obtained by Mechanically Driven Reduction Reaction of Cuo and Al Powder Mixture

The Effect of A Small Amount of Tungsten on the Microstructure of Mechanically Alloyed Ag37cu63

Nano-sized amorphous alumina particles obtained by ball milling ZnO and Al powder mixture

Solid State Reaction of Al-ZnO Powders by Mechanical Alloying

Preparation and microstructure of nano-sized Cu particles by mechanochemical reaction

Mechanical Activation-Assisted Solid-State Aluminothermic Reduction of CuO Powders for In-Situ Copper Matrix Composite Fabrication

Amorphization in the AlC System by Mechanical Alloying

Preparation of ti-al based nanophase composite powder by mechanical alloying

Preparation of Ti/Al based nanophase composite powder by mechanical alloying

Nano-sized Amorphous Cu–Zr Alloy Particles Prepared by Mechanochemical Reaction

Cu-63 Nmr-Study Of Cu83-Zn17 Mixed Powders During Mechanical Alloying

63Cu NMR Study of Cu83-Zn17Mixed Powders During Mechanical Alloying

Hydrothermal Preparation of CuAlO2 Powder

Effect of Y2O3 and TiO2 addition of dispersed powder on phase evolution and microstructural analysis of (Al, Cu)3Ti intermetallic synthesised via mechanical alloying and powder metallurgy route

63Cu Nuclear Magnetic Resonance Analysis of Mechanical Alloying Processes in Copper-Zinc Powders

Alloying of Al2Au intermetallic compound with Cu by the ball milling technique

The research of processing of Zn/Al2O3 composite powders obtained by high energy ball milling of Al-ZnO

Metastable Structures of Immiscible System Induced by Mechanical Alloying

Formation of AlCuFe icosahedral quasicrystal by mechanical alloying: XAFS and XRD studies

Mechanical Alloying, Fine Structure and Thermal Decomposition of Nanocrystalline Fcc-Fe60cu40