Abstract:Mechanical alloying was utilized to produce Mo-30Cu(wt%) composite powder. The effects of milling conditions on the powder characteristics and sintering densification were investigated. The morphological evolution during the mechanical alloying process can be categorized into four stages: 1-individual Mo and Cu particles, 2-coexistence of Mo particles and blocky Mo-Cu composite particles, 3-coarse irregular composite particles, and 4refined near-spherical composite particles or lamellar Mo-Cu composite particles, depending on whether process control agent (PCA) is added. The mechanical alloying degree of the Mo-Cu composite powder was deepened gradually from stage 1 to 4, which is influenced by the ball milling parameters. As the milling speed and milling time increase, the lattice strain and the alloying degree of the Mo-Cu composite powders increase while the grain size of molybdenum particles decreases, which is conducive to accelerating the sintering density. Among these ball milling parameters, an elevated milling speed notably accelerates the mechanical alloying process and the sintering density. Under the milling speed of 600 r/min, ball to powder ratio (BPR) of 10:1, and milling time of 4 h, the grain size, lattice strain, and average particle diameter of the composite powder were measured to be 48.4 nm, 0.247 %, and 21.04 mu m, respectively, with the particle morphology being nearly spherical. The sintered density of the Mo-Cu composite reached 98.1 %, larger than the other composites.

63Cu NMR Study of Cu83-Zn17Mixed Powders During Mechanical Alloying

Cu-63 Nmr-Study Of Cu83-Zn17 Mixed Powders During Mechanical Alloying

63Cu Nuclear Magnetic Resonance Analysis of Mechanical Alloying Processes in Copper-Zinc Powders

The Effect of A Small Amount of Tungsten on the Microstructure of Mechanically Alloyed Ag37cu63

Ageing Behavior of Cu-15Ni-8Sn Alloy Prepared by Mechanical Alloying

Study on Microstructure and Properties of Cu-Zr Alloy Prepared by Mechanical Alloying

Effect of Aging and Ball Milling on the Phase Transformation of Ni50Mn25Ga17Cu8−xZrx Alloys

Amorphization in the AlC System by Mechanical Alloying

Influence of Ball-Milling with Cu Powder on Electrochemical Properties of V-based Solid Solution Type Hydrogen Storage Alloys

Multi-component Phase-Field Simulation of Microstructural Evolution and Elemental Distribution in Fe–Cu–Mn–Ni–Al Alloy

Reduction reaction in Al-CuO powder mixture driven by mechanical alloying

Eff ects of Diff erent Mechanical Alloying Parameters on Microstructure of High Temperature Nanocrystalline Cu-Ta Alloys

Effect of ball-milling on the phase structure and hydrogen storage properties of Ti0.9Zr0.1Mn1.5 alloy

Preparation of Ti/Al based nanophase composite powder by mechanical alloying

Alloying of Al2Au intermetallic compound with Cu by the ball milling technique

Preparation of ti-al based nanophase composite powder by mechanical alloying

The Influence of Ball Milling Conditions on the Powder Characteristics and Sintering Densification of Mo-Cu Alloy

Magnetic and Structural Properties of the Nanostructured Cu50Ni50 Powders

Study on Mechanical Properties and Microstructure of Cu20Fe80 Alloy Using the Mechanical Alloying

Fracture Behavior and Structural Transition of Ni46Mn33Ga17Cu4−Zr Alloys

X-ray absorption fine structure and x-ray diffraction studies on structures of Fe70Cu30 alloys affected by mechanical alloying