Abstract:Fiber Bragg grating optical sensors are nowadays widely employed for strain measurement for structural health monitoring and in experimental mechanics. Compared to other techniques, i.e. electrical strain gauges, fiber Bragg grating offer immunity to electromagnetic interference and allow for long transmission lead lines. Moreover, thanks to multiplexing interrogation, several sensors can be photo-imprinted into a single fiber core allowing for strain evaluation at multiple locations simultaneously. They have high adaptability to composite materials, particularly because it is possible to be embedded into laminates without affecting their strength and stiffness. Fiber Bragg grating strain measurements are based on the detection of the wavelength shift of their peak reflected spectrum. However, subjected to strain gradients, the spectral response of fiber Bragg grating sensors may be distorted and the sharp peak may not be retained. In this work, the response of fiber Bragg grating sensors having different grating lengths and bonded to the surface of a carbon fiber-reinforced twill woven laminate was analyzed. The analysis combined transfer matrix (T-matrix) with digital image correlation methods. Digital image correlation technique was used to capture the non-uniform strain fields in the woven composites and measured strains were employed in T-Matrix algorithm to simulate fiber Bragg grating response. Using this approach, the effect of the length of the fiber Bragg grating on the strain measurement is assessed and results discussed. Moreover, it is shown that T-matrix formulation combined with a non-contact strain field measurement technique, as DIC, is an appropriate technique to simulate the behavior of fiber Bragg grating bonded to composite materials of complex microstructure.

Measurement of strain concentration factor of composites plate using moire interferometry

A Study on Residual Stresses in Polymer Composites Using Moiré Interferometry

Measurement Of Residual Strain And Stress In Fiber-Reinforced Composite By Electron Moire Method

Messung Der Beanspruchungsfaktoren Von Einer Verbundfaserplatte Mit Hilfe Der Moiré-Interferometrie

Investigation of Strain in Microstructures by a Novel Moire Method

Multi-Directional Strain Measurement in Fiber-Reinforced Plastic Based on Birefringence of Embedded Fiber Bragg Grating

Residual Interlaminar Deformation Analysis in the Carbon/epoxy Composites Using Micro-Moiré Interferometry

A novel approach based on stress-impedance effect to assess the interfacial properties in fiber-reinforced composites

On Strain Measurement Of Braided Composites Using Co-Braided Aefpi Optic Fiber Sensors

Investigation of Residual Stress in 2D Plane Weave Aramid Fibre Composite Plates Using Moiré Interferometry and Hole‐Drilling Technique

Focused Ion Beam Nano-Machined Structures for Strain Analysis by A Moiré Technique

Strain Measurement with Optic Fibers for Structural Health Monitoring of Woven Composites: Comparison with Strain Gauges and Digital Image Correlation Measurements

Experimental analysis of the response of fiber Bragg grating sensors under non-uniform strain field in a twill woven composite

Strain Measurement of Particle-Reinforced Composites at the Microscale: an Approach Towards Concurrent Characterization of Strain and Microstructure.

Application of Moiré Interferometry to the Characterization of Orthotropic Materials in the Antisymmetric Configuration Using the Virtual Fields Method

Measurement of Poisson Ratio of Composite Materials Based on Tridimensional Digital-image Relativity Method

Hole-drilling Method Using Grating Rosette and Moiré Interferometry

Experimental Study on Residual Stress Measurement Methods of Moiré Interferometry Based on Ring-Core and Slitting

Fiber Optic Sensing Textile for Strain Monitoring in Composite Substrates

FIB Moiré Gratings and Their Application in the Measurement of Optical Fibers' Mechanical Properties

Experimental investigation of trans-scale displacement responses of wrinkle defects in fiber reinforced composite laminates