Abstract:Since fiber-matrix interface strength is critical to properties of carbon fiber-reinforced composites, measurement and analysis of interface strength are crucial steps in tailored design of composites. In the present work, the single fiber push-out test and the short-beam shear test were applied to measure the fiber-matrix interface strength in uni-directionally and two-directionally carbon fiber-reinforced phenolic resin matrix composites. The technical difficulties in processing the specimen and in realizing the fiber push-out were also discussed and clarified. For obtaining the successful test, typically, the thickness of the specimen should be smaller than 100 mm. During the fiber push-out, the de-bonding and fiber sliding at the interface were analyzed from the load-displacement curve features. The results indicated that both methods could be applied to determine the interface strength. The single fiber push-out and the short-beam shear tests resulted in a similar phenomenon in regard to the interface strength of uni-directionally and two-directionally carbon fiber-reinforced phenolic resin matrix composites, but expressed different values. The low interface strength measured from the short-beam shear test could be associated with multiple interlaminar shear failures. Furthermore, it was found that the interface strength of uni-directionally carbon fiber-reinforced phenolic resin matrix composites is somewhat higher than that of two-directionally carbon fiber-reinforced phenolic resin matrix composites. The difference in the interface strength could be attributed to the thermally induced residual stresses caused by the coefficient of thermal expansion mismatch of fiber and matrix. The approaches applied in the current work can be used for the evaluation of the interface strength of carbon fiber-reinforced phenolic resin matrix composites with different fiber-matrix bonding properties.

Measurement Of Residual Strain And Stress In Fiber-Reinforced Composite By Electron Moire Method

Measurement of Residual Stresses in Fiber Reinforced Composite Material

A novel approach based on stress-impedance effect to assess the interfacial properties in fiber-reinforced composites

New Method for Interfacial Evaluation of Carbon Fiber/Thermosetting Composites by Wetting and Electrical Resistance Measurements

A Study on Residual Stresses in Polymer Composites Using Moiré Interferometry

Pre-use Interfacial Shear Strength Prediction for Fiber-Reinforced Thermosetting Composites Based on Stress-Impedance Effect of Ferromagnetic Microwires

Residual stress in fiber reinforced thermosetting composites: A review of measurement techniques

Measurement of strain concentration factor of composites plate using moire interferometry

A Micro-Scale Strain Rosette for Residual Stress Measurement by SEM Moiré Method

Residual Stress Measurement on a MEMS Structure With High-Spatial Resolution

Residual Interlaminar Deformation Analysis in the Carbon/epoxy Composites Using Micro-Moiré Interferometry

In situ interfacial evaluation of aramid/epoxy composites by interfacial stress transfer characteristics

Determination of residual stresses in metal matrix composite

Full-Field Measurement of Residual Stresses in Composite Materials Using the Incremental Slitting and Digital Image Correlation Techniques

Measurement of Non-Uniform Residual Stresses by Combined Moiré Interferometry and Hole-Drilling Method: Theory, Experimental Method and Applications

Strain Measurement of Particle-Reinforced Composites at the Microscale: an Approach Towards Concurrent Characterization of Strain and Microstructure.

Experimental Study on Residual Stress Measurement Methods of Moiré Interferometry Based on Ring-Core and Slitting

Measurement and analysis of fiber-matrix interface strength of carbon fiber-reinforced phenolic resin matrix composites

A Study of the Residual Stress and Its Influence on Tensile Behaviors of Fiber-Reinforced Sic/Al Composite

Focused Ion Beam Nano-Machined Structures for Strain Analysis by A Moiré Technique

Relationship Between the Depth of Drilling and Residual Strain Relief in Fiber Reinforced Composite Materials