Abstract:Femtosecond laser processing technology offers a promising technique for the preparation of micro and nanostructures of single-crystal silicon carbide (SiC), thanks to its high precision and non-destructive processing. However, further research is needed to optimize processing parameters, as well as improve efficiency and quality of the process. This study conducts experiments to explore the effects of femtosecond laser ablation on single-crystal SiC. The influence and significance of parameters, such as fluence (F), repetition rate, scan speed (S), multipass scanning (c) and numerical aperture on the performance of grooves, including groove depth, groove width, heat-affected zone (HAZ) width, material removal rate (MRR) and side wall inclination angle, were studied. The results show that the influence of fluence and numerical aperture on groove depth, groove width, HAZ width, MRR and side wall inclination angle is very significant. The scan speed has a very significant effect on the groove depth, groove width, HAZ width and side wall inclination angle but has insignificant effect on the MRR. Repetition rate and multipass scanning have a very significant effect on groove depth, HAZ width, MRR and side wall inclination angle and a moderately significant effect on groove width. The experimental methods of increasing the aspect ratio and reducing the HAZ width were studied, and a significance analysis was carried out. Fluence, multipass scanning and z-layer feed have significant effects on groove depth, groove width, aspect ratio, HAZ width and MRR. The influence of polarization angle on groove depth, groove width, aspect ratio and MRR is insignificant.

EXPERIMENTAL STUDY ON DIFFRACTIVE PERFORMANCE OF CONCAVE GROOVES WITH SUBMICRON WIDTH

Research on the optical field distribution and micro-fabrication model in convex-surface laser lithography

A New Subdivision Technique For Grating Based On Cmos Microscopic Imaging

Laser Direct Writing Technology for Printing Mesh on Convex Surface

Optimization and Fabrication of Chromium Grating in Self-Traceable Interferometer

Groove-structured Meta-Surface for Patterned Sub-Diffraction Sound Focusing

Experimental research on diffractive performance of the rectangular gratings with micron or submicron period

An Experimental Investigation of Groove Control for Reducing Drag in a Flat Turbulent Boundary Layer

Experimental Research on CO_2 Laser Direct-writing Machining PMMA Microchannel

Improved Master-Replica Separation Process for Fabrication of A Blazed Concave Grating by Using A Combination-Type Convex Grating

Experimental study of a new micromilling process for vortex curved thin walls

Fabrication of nanoscale gratings with reduced line edge roughness using nanoimprint lithography

Investigation of Micro-wear and Micro-friction properties for bionic non-smooth concave components

Demonstration of synergic Fresnel and Fraunhofer diffraction for application to micrograting fabrication

Design and characterization of a micronfocusing plasmonic device

Study of diffractive fringes caused by tool marks for fast axis collimators fabricated by precision glass molding.

Experimental Study on Femtosecond Laser Processing Performance of Single-Crystal Silicon Carbide

Experimental Research on Deep-And-Narrow Micromilled Grooves Using a Self-Fabricated PCD Micro-Cutter

Experimental Research on Dry Etching and Wet Etching of Head Sliders in Hard Disk Drives

Research on focusing system characteristics and defocusing application in laser direct writer

High-precision defocus detection through a bevel-axial stripe pattern projection method